I am running a 6.0L with the Honey Badger cam. I have upgraded the springs, push rods and lifters. I have 34lbs injectors, a TBSS intake and shorty headers. When I start the engine, It runs great until about the 23 seconds then it starts into the lean condition. It will migrate up to 1.25 lambda and the engine will have some surge. around 55 seconds of engine run time it will go back to normal. I have tried adjusting some things (Fuel Mult stage 1 and 2, and base running idle air flow to name a few) but nothing has brought this back to where it should be. I am not sure what is changing for that ~30 seconds and where to adjust. I have included a few logs of startup so you can see and my current tune. This is a speed density tune where I just failed the MAF. This is not a speed density OS. Where do I adjust next?