Am I the only one that can't access the min fuel mg under the transient tab? I have updated to the latest version and it isn't showing for any tune file.... I'm sure I'm not imagining it being there
Am I the only one that can't access the min fuel mg under the transient tab? I have updated to the latest version and it isn't showing for any tune file.... I'm sure I'm not imagining it being there
Sounds like you have Basic view selected instead of advanced.Originally Posted by VXSS
Edit > View > Advanced
That's a Gen 3 thing, isn't it?
Yeah, I think you are right
My view is set to advanced. So nobody else has this issue?
I think blindsquirrel is suggesting that's something used in GEN3 but not GEN4.
Hmm I'm so sure I have adjusted this before in gen 4s
There is a similar cal in series 8, but it doesn't work exactly the same way as the min fuel milligrams cal. What are you trying to do?
I'm trying to reduce a rich decel. I have dropped the minimum pulswidth under the fuel tab and its not too bad but I'm sure in the past I have adjusted the transient - min fuel milligrams also
If the tip-in isn't lean at all (and everything else is fine, hardware in particular), then increasing the accel/decel ratio table can help that.
I will give it a shot. Thanks
Can anyone tell me if the maf tables are referenced even with no maf connected running olsd? This thing just refuses to pull fuel at decel at times. Can get down into the 10s seems to be inconsistent about it though
Reply With Quote