Hello, i have a list of parts i'm going to use and any help with a basic safe tune setup to break in the engine so later when i install a turbo after 3k to 5k miles. I know then full engine will need to be tuned again. At that time i'm gonna have a shop setup 3 tune packages.
Parts list
LQ4 bored .030 over - Summit racing rotating assembly 370cubic in, stock stroke of 3.622, bore 4.030, rod 6.125, 12cc dish, 9.7:1 @ 70cc (Pro LS 4340 - SUM-R2436L03012)
Injector Bosch LS3 compact 2.0" - 12.8 Ohms, 37.5lbs/hr @43.5 PSI, 42.3lbs/hr @ 58 PSI part number by GM 12576341 (where to find injector maps to load into tune)
TB stock 87mm Drive by wire
Fitech intake.
Exhaust is 1 7/8" long tube headers.
Do i need a stronger fuel pumps now or wait until turbo kit install time.
Here's the tune file i pulled from the stock LQ4 thats in the truck.
Also im from the Marysville Washington area if anyone is within 50 miles and could help me with the project. i;m gonna be putting the engine in the truck this spring.
Why not go ahead and get injectors big enough for the future turbo setup?
Might as well go ahead and put in a better fuel pump during the build so you know thats in there and ready for the turbo.
Reply With Quote