Originally Posted by
JSH
1. Delete contents of folder, HP Tuners\VCM Scanner\Vehicles
2. Download current HPT Suite (or Beta) and MVPI drivers,
3. Connect the laptop to OBDII,
4. Put the car in service mode, WB should power on,
5. Wait 20 sec. for WB sensor to warm up,
6. Select mode "obd2" on the AEM gauge,
7. Close HPT Editor and open Scanner.
8. Click "connect to vehicle" in scanner,
9. Vehicle>Repoll vehicle parameters,
10. Click gear icon with green + "add channel"
11. [add new channel] dbl click "WB EQ Ratio 1 SAE " under OBD2 [I don't remember the entire channel tree]. Do not click any External Inputs.
12. Click "Start Scan", the WB channel should remain in list and display active scan data.
13. Push ignition button to exit service mode.
14. Start engine, start scan, and the WB channel should display active scan data.