The safety overpressure valve in all Gen5/SS cars is 85psi. If battery voltage is applied to the fuel module the pressure will vary from 85psi to something much lower at WOT depending on fuel demand....
Type: Posts; User: carlc
The safety overpressure valve in all Gen5/SS cars is 85psi. If battery voltage is applied to the fuel module the pressure will vary from 85psi to something much lower at WOT depending on fuel demand....
If that's the case what is the best course to have it checked and how best to reference the problem?
Keith,
Thank you for the feedback. However, as stated above, when the inputs are connected the noise is amplified. It gets worse.
"When attaching a pressure sensor to #4, the "noise" gets...
Being a bit of a HPT newbie, thanks in advance for the help.
Using V3.6.16 downloaded earlier this week. New Ballenger AFR 500V2 standard connected to a 2011 EIO. The tune is essentially a 1bar...
First time starting a post so please be gentle... :pray:
I have been using 2.24 to scan a Gen3 0411 ECM. Three auxiliary input PIDs (fuel pressure, WBO2, and External MAP sensor) have been added...
Thanks tommy! If it appears that by trimming the spring guide pins the overall installed height could be reduced, I'd appreciate your opinion on that too. No worries, I'm not holding you to anything....
Gentlemen,
I'm considering retro-fitting this module into an early Camaro. If someone has a module on the bench can you please list the extended and compressed height of the module when measured...