had to hold tb open a bit to start it. Let go and it shuts off
Type: Posts; User: bsaathoff73
had to hold tb open a bit to start it. Let go and it shuts off
sorry. Ran in to my uncles.
Pop after 150 degrees. 16 until I shut off. Not near as many. More closer together towards the end
Yes. Its set for the damn ignition box still. I apologize. i will start on it now.
Ok. So i think im stupid or im not remembering. Probably both. I have to look at some things i did prior to you with the others. As im looking here now. I may not have my coil connected right. I...
was so much better. Not near as many pops and were kinda stretched so I got to run it to 187.Around 180 is where it began to pop more and more. Thats when I shut it down. Pretty damn excited over...
I apologize. For ignition i think of key n timing. Key. Nothing. Timing. Should be set right. Motor was built at a reputable shop. Timing. Msd coil, msd opti. 411 swap. Im pry off on what you meant.
I put the screw in a bit. Then did a half turn. Can see blades got tiny crack now. No change on the volts.
I will do this today after work. Pry around 7 or 8 tonight. Thank you.
I can stop at menards tomorrow after work n get a 32nd bigger. just let me know.
Yes. Completely backed out. I dont think the blade moved at all.
tb backed out to where I can see a gap between the screw and accelerator arm. Sounded better. Temp got higher before popping. drill bigger? Its a 3/16 now.
3/16 hole
here is a new log. I drilled a hole just smaller then stock size. Hopefully its better
I always shut off after a few pops. I dont know if i should keep logging for a bit or... Heres todays scan.
heres 2 scans. I have no idea whats going on.
Wiring is in correct spots. I'll look how to check signal from pcm.
Im out there now checking it out. Harness tested ok. So now gonna look at the pcm and make sure wiring is correct.
Thank you.
heres a new scan. Both are new 02 sensors. Hopefully they are both working. If bank 2 is not, its gotta be the 02 extension harness then.
I didn't know both were bad. I'll order another one. Both pretty much brand new. Only start times on em. But yeah, ill get a new one coming.
And change the commanded eq
Thank you
I do have...
Here is the newest scan. It pops after a minute. Loud. If I open the throttle blade a bit it stops. My chart layout and stuff is off. I will try to fix it today
Yeah. Nim nut here left the pc on top the car and it vibrated off. Broke. New pc now but..... Have new tune in car. In vcm scanner to set the table,it wont show intake man press 2 bar. So i selected...
Got the bung, narrow and widebands installed. Fired it up on your last tune. Runs way better now.
Want me to load the other tune and go for a short drive?
Im 50 years old. I was raised to respect others and my neighbors. To help others in times of need. Yes. I do appreciate it. I just dont post it here. I private message him also. i will do him...
Ok. Ill put wideband back in. Want me to start and log it again?