Search:

Well just lowering startup airflow helped heaps. Appreciate the help! Will post a log here soon

Ty sir

Yessir that is something I noticed was flatlined also…I have a dyno appt on Tuesday I’ll get a good excuse why the tuner didn’t wanna put the time into dialing this table in lol. How does this table...

I will take some g/s out of the startup airflow table (ecm 12194) and see what happens, this table is only referenced for 4 seconds after startup?

something to note in the log posted above; the...

howdy, I get a really lean spot on my hot starts, doesn't happen cold. vehicle drives great. any help is appreciated

145643

145644

thank you i will log those channels

It’s just a single disk, not normally locked during WOT, did that to see if my surging/bucking issue changed. Do you know what a negative trans slip rpm means?

trying to chase down a very noticeable surge in power (bucking sensation) while doing a pull in 5th and 6th gear. i do not think its engine management related, i noticed the TRANS SLIP RPM pid has a...

for it to be proper you need to dial in vve at least where the ecm references it the most (at idle), not hard to do since the rest of the tune is perfect...lol

OEM uses needle bearings for a reason. BTR sells quality components. Sounds like user error.

if its not solely used for drag racing may want to consider using a maf sensor

roger thanks

fwiw I have a small turbo/quick spooling setup and I have PE coming in at 95kpa and 5% throttle....

good info thank you!

ahh no lol. Where would I get 5v from to send to the sensor?

I am trying to setup a fuel pressure and oil pressure gauge through the two prolink analog inputs, using 0-5v, 0-100psi transducers.

If I am understanding this correctly;

Connect signal wires...

I have an e67/t43 in a custom application.

It has no theft prevention besides door locks/ignition key.

Is there anything wrong with installing a kill switch and cycling often like once a day?...

LOL @ holley & "seemless."

srry to hear about your troubles, the pcs setup is a much better product imo. considering you have a holley termi setup id assume you dont have any HPT interface to hop...

okay ill do a closer look at misfires just to be sure they arent related, the issue did point me towards misfires at first, but after looking at my misfire sensitivity tables they are almost cut in...

srry took me so long to post files;142541142542

note: MUCH has changed from the stock file to the one I have currently in the truck, so if I have something completely wack or out of place please...

Went on a drive this morning to see if it would lockup and it did not, setting the ecm vss to the correct value didn’t make any changes to my knowledge. Peculiarly, I shut the truck off to get my...

Thanks for this

I did show a few misfires but nothing extraordinary, I went down that rabbit hole and didn’t find much. I have heard of excess misfires not allowing lockup tho. Thanks for the suggestion

Curious how it could have locked up at all? If the tcm and ecm had completely different values.

Well I’ll be a darn fool my ecm and tcm vss values were not the same….the tcm had the correct value but the ecm didn’t. I sure hope that was the problem I’ll report back. Thank you for the replies