I know on the LNF if you set the DTC to 3 it never sets the tests to ready...well on a sky that is...YMMV. Looking up the drive patterns required to set everything to ready is helpful if you are on...
Type: Posts; User: COSky
I know on the LNF if you set the DTC to 3 it never sets the tests to ready...well on a sky that is...YMMV. Looking up the drive patterns required to set everything to ready is helpful if you are on...
Have to ask, are you viewing everything in advanced/expert mode? Also, have you contacted support with this issue? They have been helpful for me in the past, just remember they are busy people,...
Anything running outside the measurable parameters will be uncontrolled, and can vary greatly with temperature, altitude, and humidity amongst other environmental changes.
Think about a...
PID.2360 limits at 255 kpa as far as I know. PID.2338 Boost lo-res, seems to read up to 512 kpa. Remember to subtract baro pressure to get a more accurate boost reading. I think it's PID.51 but it...
Third post "factory wideband is junked." I had the same issue on my 07 sky, wideband died no code just crazy fuel dumping, took me a little while to figure it out.
If you are familiar with the registry editor you can try removing the following registry key:
[HKEY_LOCAL_MACHINE\ SOFTWARE\ Microsoft\ NET Framework Setup\ NDP\ v#.#.####]
OCM=1
The # will...
I use an hp netbook with windows 7 starter on it. Everything works fine, just a little slow loading, but once the software is up it's no different than my gaming laptop. I would note that the...
http://www.hptuners.com/forum/showthread.php?t=38357
That thread has a link for every question in your post. It has a ton of info on just how far every can or has be/en pushed. Nick's tuning...
For what it's worth the Yellow wire on Pin A is the MAF signal wire and the Black/White wire on Pin B is the ground. Problem is the MAF is frequency based and does not output a 0-5V signal. You...
Electronics (and really any personal property not related directly to the vehicles operation) left in the trunk of a car will most likely not be covered by your vehicle insurance. The people you...
So you have a 5v source going through a thermistor in to the MPVI Pro? If you are getting something less than the 5v reference your thermistor is working assuming resistance goes up as temperature...
c131frdave you have a PM, I can host the file for you if you'd like.
You might get a lot better response if you let people know what you have and are looking for. We know it's probably a 2.2 ecotec but that doesn't really say a lot.
It's like walking up to a fruit...