edcmat-l1 Is this something you could retune for me? I realize this isn't a GMPP tune.Should I move this post some where else?
Type: Posts; User: Luweegy
edcmat-l1 Is this something you could retune for me? I realize this isn't a GMPP tune.Should I move this post some where else?
DSTECK,
This is my tune.I've got a surge @ 2k rpm's and after i come to a stop the idle will creep up to 1400 rpm's? NW 102 TB,Lsxr 102 intake.Cam Specs are,SDPC Super stick 4,248/262,113 lobe...
I have to click on it 6 times to get to my change log. it Get Constant
ID:4001
...
I installed a NW 102 TB on my 06 Z06.What do I have to change in my tune?
I thought I would post a update on this problem.Turns out it had a 3:90 rear gear.I set it for that used autoscale and all is good.Thanx for the help Guys!!!
I Ck'd the trans oil level and fluid condition.It was down a pint.Smelled fine.Russ, I just called Dynotech with the rear end serial # it has a 3.90 gear.26" tall drag radials.I got this car not...
I tried your tune edcmat, still doing it.1-2,2-3 hits the rev limeter.Should I raise the fuel cut off to 6700 RPM's?
I see it now.I didn't know you reworked my tune. I will put that in tomorrow and let you know.Thank You.Update, I tried your tune.Same problem.Another thing I will add is it shifts at 2k RPM even...
Thank you, I will adjust that and see what happens.Should I drop my shift points 5mph?
I will try that
Yes it is.What is wrong with the speedo?I'll go look at it now.
I've tried to figure this out,Newbe to trans tuning.I had someone look and adjust for me.But the same result.3:42 gears,2600 stall,3.75 pulley.It hits the rev limiter in 1st gear before shifting,...
I have the Beta Version and have read and tuned a 2010 Camaro LS3 with a Novi super charger. Can't access the crate motor ?
I understand opening the 2 files Do I rt click to copy everything over?Thanx for the help. I have such a mental block when it comes to understanding these tuning programes for some reasonI just can't...
I've got a tune I bought credits for,06Vette LS2 tune with cam,headers, and a K&N ais. I want to put this same tune in another 06 LS2 Vette I've done the same mods to.I know I have to use 2 credits...
Got anothe ? What color wire am I looking for off the TPS on a 01 Vette?And what wire color and posisiton on the PCM is the tach signal.I'm all wired except for this and don't have a C% GM manual...
Pinched wire from bell housing removal? I had that happen once and it ran like it was on 4 cylinders.
I'm gona use TR-6's to start with. Thanx for the help so far.
[QUOTE=madvette08;221223]Start with 12 degrees of timing from 0.60 cylinder airmass and higher and 2800 rpm and up.
Add 10% fuel from 2800 and up in the Power Enrichment EQ Ratio vs. RPM table....
I've got a tuned LS6 24018 Can someone help with a wet plate 100-150 shot tune?
What is the setup if I'm using a AEM wideband?
The code it had said no comunication.So Another predator burns a PCM.4rth differant car this summer.06 vert,03 Terminator,03 Saleen Terminator and now this one.WTF good thing I'm in Colorado and...
I've got a 04 C5 that had a predator tuner in it.I was changing fan temps and reloading the changes.The tune aborted,set a code,that said no comunicatio to the TB.The car won't start.I was gonna tune...
I've tried to turn of this code.it is F terminal on alternator.I'm getting ck charging system on the DIC in my 06 Z06 everytime the rpm's are low or coming down to idle.I've turned off other codes.Am...
Bill, has anything been done to get the fan to come on before 192 degrees in the Z06 LS 7 tune yet? Thanx