guys i always looked at the oil pressure a little bit during tuning the car with the HP Tuner and it seemed that it rises from 320 kpa to over 450 under full load at 100% TPS with a 10W40 oil. Now i...
Type: Posts; User: hotparts
guys i always looked at the oil pressure a little bit during tuning the car with the HP Tuner and it seemed that it rises from 320 kpa to over 450 under full load at 100% TPS with a 10W40 oil. Now i...
I have big problems with the cold start. The motor dies off the first times an doesn`t react at the gas pedal.
After 6-10 trials it runs and then it is no problem. The motor also dies at the cold...
Where can i find how to set the ignition reduction when the wheel spin is to high at a C5 Corvette or how can i completely shut off the TCC?
Thank you
Hi guys,
is this cable a stock OBD2 to RS232 pin configuration like you can order it everywhere?
http://www.obd2-shop.eu/obdseriellesrs232kldiagnoseinterfacefertiggert-p-166.html
I need a...
I`m from Salzburg in Austria. It is next to germany
That would be great and here in germany there would be a lot of interested people!!
????????????????????????????
can nobody help me :shrug::shrug::shrug::shrug::shrug::shrug::shrug:
Hi guys,
with the Beta version i can`t find how to set an alarm (display changes to red)?
The gauge properties look different than in the help.
Can i add a oil pressure and fuel pressure gauge...
Bill now i installed my software but it doesn`t take the Key!
I put it in with copy and paste like i did it with my old HP Tuner after setup but it doesn`t take it, it is the wrong key.
...
It has too many bugs. Do you have an other idea?
I can`t find Net Framework 2.23. Please send me a link.
Thank you Bill
I found it but i have an other problem.
I have Net Framwork 4 and when i install the Software it asks for Version 2. When i try to install Version 2 it says that it is still part of the system (i...
Hi guys from HP,
i had an interface since years but not the pro Version. Now i sent the old one and got the new upgrade but i can`t login at my old account!
I also can`t create a new account! ...
If you want i could ask a technical translater here.
Send me the descriptions, then i could ask for a price but i`m sure that there are a lot of guys that would buy a german HP Version!
:yay::yay:
:worship: It would be great and you could sell a lot of HP-Tuners because here in Europe are many german speaking countries.:usa:
Hi guys,
is there a german version eisting or planed?
Thank you:usa:
PID for the AFX NGK Wideband controller hooked in the AC line
--------------------------------------------------------------------------------
Hi guys,
till now i used the LC1 sensor hooked...
Can nobody help me :shrug:
Hi guys,
till now i used the LC1 sensor hooked in the AC pressure line and a gauge for permanent control during driving.
A buddy told me that the LC1 sensors are not so accurate after a while,...
Thank you Ed
Guys, i`m to stupid to find the IFR table at my HP tuner.
Where can i find the table and what is the exactely name?
Thank you
Hi guys,
i have a reduced engine power mode at 4400 rpm at full throttle.
What table do i have to change and how?:secret:
Speed density tune at a Corvette C5 402 Ci VSY V7 vortech with the...
Thank you:crazy:
Hi guys,
i have a 3795 LC1 from inovate motorsports
It is set like this from the factory
0v => 7.4
5v => 21.8
Can you tell me what is the right PID for it and where to put in?
After a...