Search:

Check out Dan Maslic's idle tuning on Youtube, it helped me.

I'll see if I can get the file there and look at it. Thanks.

Not sure how to open the file and make sense of it.

Does anyone have an explanation of what traction control torque and traction control desired torque means?

I did a re-log with more PID's. Nothing stands out except for burst knock at the initial hit of the throttle, which I assume is normal? I'm still not sure what traction control torque and traction...

I'll re-log with your suggestions and re-post. Thanks for your time.

Thanks for the reply. I'll add these PIDs to my list. I think it might be a traction control issue. The traction control torque percentages drop when the timing is pulled. If you have the time, check...

Is there a way to tell what system is retarding engine timing? When going full throttle, the timing drop to 17 degrees retarded then slowly recovers.

Any help out there?

How can I capture an event on the scanner? I would like to add a notation to a specific event to review that data later. When I hit the space bar it pauses the data then starts over.

No neutral safety is wired into the ECM. I'm starting to tune the idle. I bought the ECM from spare ECM, I believe it's set up for an automatic. Is this the default setting? So I just work with the...

And I thought this would be an easy question. Anyone?

When tuning my LS1 with a 200R4 behind it, I come across settings for P/N and Drive. Do These settings / tables get used for this setup?

I was attempting to follow a book and lost site of the big picture. I'll look at this and see where it leads me.

Thanks to all

Sorry, I missed the link, Thanks

I was following the book, but it's either wrong or I did something wrong. Should I disconnect the MAF? Turn off fuel trims? What else?

42827
42830
42828
42829


I’m trying to tune my first engine build using Dan Maslics “Master EFI Tuner” book with HP Tuners (basic). I’m using Case Study 3 and can‘t get past the...

I'll have to try that this weekend.

Thanks

That's an option, but it doesn't feel like there is a misfire and the ECM is not reporting one. Anything in the tune that can cause this? I've measured the powers and grounds, checked the injector,...

Went on my very first test drive with my fresh engine and ran across a check engine light with no real drivability issues. Pulled a code P0200. No other codes. So I drove it home and parked it. I...

That would be a big help. Had I known this going in, I would have taken another route. I replaced the both O2's, so they seem to be switching normal? but the engine still won't idle, so I'm back to...

That will be the first repair. Thanks for the reply.

Would this be the "Base running Airflow, Idle airflow"? What is a good starting point?

I'm still new to this, I tried some suggestions that may not have been the best. I'll try to take a look at this and see if it helps. For some reason my laptop won't read a .cfg file, so I'll have to...

I've been reading for a month straight, but most of the information I've read is from 2006 & 2007. I have a fresh build that won't idle. I have to keep the throttle at 8% or higher to keep the engine...