Search:

Type: Posts; User: gagliano7

Page 1 of 10 1 2 3 4

Search: Search took 0.00 seconds.

  1. Replies
    8
    Views
    1,608

    There are 2 04 4.8 5 speed in the tune repository...

    There are 2 04 4.8 5 speed in the tune repository which will help you.
  2. Replies
    26
    Views
    5,540

    How does the suburban feel with the 6.0 compared...

    How does the suburban feel with the 6.0 compared to the 5.3? I also noticed your WOT timing is really low. Once you get that dialed in it will make a big difference. When i upgraded to the 50 lb...
  3. Replies
    2
    Views
    777

    Just copy from the tune repository to your pcm....

    Just copy from the tune repository to your pcm. Takes a little bit of time but it is pretty easy.
  4. I have a 1992 with a 5.3 with stock tach. I have...

    I have a 1992 with a 5.3 with stock tach. I have tach output high 3 and low 3. Works perfect.
  5. Do you have AFM turned off yet? The only time my...

    Do you have AFM turned off yet? The only time my trans acted like was when AFM was on. With it off no more trans problems.
  6. Replies
    4
    Views
    1,637

    Thanks

    Thanks
  7. I have the same setup. I just tuned the engine...

    I have the same setup. I just tuned the engine side with some timing, E85 compatible, and turned off A FM. My trans shifts perfect with afm off.
  8. Replies
    4
    Views
    1,637

    Thanks I was hoping it was that easy. Where is...

    Thanks I was hoping it was that easy. Where is the auto scale transmission settings box?
  9. Replies
    4
    Views
    1,637

    2018 Sierra 6.2 gear change

    I am going to change my gears from 3:23 to 3:73. This might be a dumb question but the only thing I see I need to change is the gear ratio in speedo programming. Is there more than that or am I all...
  10. Replies
    7
    Views
    6,722

    What did you change in the Factory Alcohol...

    What did you change in the Factory Alcohol Content Timing Adder Table?
  11. Replies
    13
    Views
    4,309

    So now ford has the easiest ecm's for tuning? I...

    So now ford has the easiest ecm's for tuning? I wonder how much it will cost to have these worked on down the road when the warranty is up. Gonna have to take out a loan for repairs.
  12. Replies
    33
    Views
    14,685

    Zero out the knock retard tables under the spark...

    Zero out the knock retard tables under the spark retard tabs to see if that stops pulling spark. Since you are only working on idle it won't hurt anything. Also log knock to see if that is pulling...
  13. Replies
    23
    Views
    6,124

    The ltit and stit will be close to 0 when you get...

    The ltit and stit will be close to 0 when you get your RAF #'s correct using the Russ K Config.
  14. Replies
    2
    Views
    1,105

    Your STFT and LTFT are tuned off in the tune so...

    Your STFT and LTFT are tuned off in the tune so your 02's won't do anything. This is usually done to tune with a wideband then you turn them back on when you get the ve and maf dialed with the...
  15. Replies
    8
    Views
    4,250

    You will need to put the LS sensors on your SBC...

    You will need to put the LS sensors on your SBC engine. The big thing is getting a crank sensor that will work with your pcm and engine. I think you would be better off with a holley system or...
  16. Replies
    23
    Views
    6,124

    That cam is actually a 222/225 112+4 at .50. If...

    That cam is actually a 222/225 112+4 at .50. If it was a 272/281 in a 5.3 good luck with idle.
  17. Replies
    3
    Views
    1,525

    When i looked at a tunes for both coils they had...

    When i looked at a tunes for both coils they had all the same parameters in the tune. I had squares when i got my motor and swapped to heat sink coils and didn't change my tune and everything works...
  18. Replies
    3
    Views
    1,525

    Take a temp gun and check all the primary exhaust...

    Take a temp gun and check all the primary exhaust port temps. If there is one a good amount cooler than the rest that is your problem cylinder. I had a similar issue and doing this test i found out...
  19. I noticed one thing you have some knock problems....

    I noticed one thing you have some knock problems. I also noticed when your idle dropped in the beginning your spark dropped big time. I would check all your spark tables in the area where you have...
  20. Sounds good. I compared your Battery Offset with...

    Sounds good. I compared your Battery Offset with a 2012 Sierra 2500 6.0 and yours is spot on. Thanks for the info.
  21. I was looking at the battery offset and they are...

    I was looking at the battery offset and they are way different, short pulse adder and minimum injector pulse width are also different.
  22. Here it is.

    Here it is.
  23. I just wanted to know if this injector data is...

    I just wanted to know if this injector data is correct. I found the data for the 12613412 injectors on LS1tech and the data is different then the data here.

    Thanks
  24. Replies
    10
    Views
    3,662

    I had a very similar cam in my 5.3 loved that...

    I had a very similar cam in my 5.3 loved that cam. I would start with 22 degrees timing at idle for that cam as a starting point.
  25. Replies
    10
    Views
    3,662

    Your raf Base running airflow looks low to me. I...

    Your raf Base running airflow looks low to me. I have a 5.3 heads and cam and my #'s are higher. Run the Russ K idle config to get your #'s correct. TIming seems low at idle for a cam. What are the...
Results 1 to 25 of 229
Page 1 of 10 1 2 3 4