Yes, that is one for all.
All opamps are on the same ground
Type: Posts; User: iGoRa
Yes, that is one for all.
All opamps are on the same ground
the table goes from 0 to 16. for example if i have twice as lage injectors installed , can I just multiply entire table x2?
table filled with 1.
How I understand , this is a multiplier. What does it do, multiplies FlowRate vs. KPa table for each cylinder?
Wideband way for noobs:
http://www.turbofirebird.com/Tuning/MAFTuning/tabid/63/Default.aspx
NB is similar , use the fuel trims instead. The trick is that you have to lock at 0 for PE mode and...
Im sure that have been done before
-will something simple work like programming LED to turn On on knock or act like a shift light?
- would HPT EIO work after programming as stand alone(no...
its there
Thank you guys I almoust got it installed 8" away from the turbo, Now will move it all the way down.
HBX-1 - is it just like a little piece of tube that goesh between O2 and pipe?
Ive planed to...
I want to have my WB installed permanently.
With the same tune:
First I had my LC1 installed in pass manifold. Worked great on the cold car and was throwing Error8 (overheating error) if I...
yes , you can do it thru VCM Controls. check out my site.
every time you let off the gas it must go lean, how do you think gas is getting into exhaust if you injectors are closed?
yes , we have all that that done. I understand every part and step in maf tuning process.
thats slow6 scan , as you see ~1100 he locked FT at 0 and his AFR went from lean to normal.
When car is in open loop and fuel trims are reset to 0 Commanded AFR=WB which is good , but as soon as I exit open loop , fuel trims droping to -15% and leans to ~16.2 (slow6) and -5% on my car. As...
wow, thats really bad. Your nb shows too rich and pcm removes 25% of fuel , cant see your Commanded and WB AFR.
did you put smaller pulley or something? I would take like 10* of timing out of top...
O2 voltage - error. Look in the status bit display. As soon as I start the vehicle I have that error reported too . Im pretty sure that everybody have that.
Im looking for 2002 v6 Auto stock tune file for f-body. Searched repository.
little help please.
got it. I was about to ask another question , but you got it covered.
I know what to do , if everything will go smooth will finish my writeup!
Russ , what a great guide.
I have a few questions tho:
you mean to PE enable TPS to 0% or to 100%? (you are trying to disable PE mode here , right?)
I dont understand what is this that will...
All WB controllers should be grounded directly to the battery ground to avoid ground loops,voltage shifts, el noise. Just run speaker wire thru the firewall(pass side, behind PCM) to the battery...
guys , first of all we are dialing MAF, not VE. So do not disable anything , especially MAF.
Slow6 email me your logs,tune and mod list.
i did
I think that whats going on, .12 doesnt open beta.
where can I get beta from?
I have a problem while opening my tune file
Error:
Unable to open file.
File validation check.
anybody could try on their computer and tell me if it works?
could not figure out is it a file...
the only reason that I have it in manifold, my entire exhaust is going to be redone, I will move it right before cat after its done.
I have mine VE dialed in with wideband.