Thanks!
Type: Posts; User: zaxrx
Thanks!
Hello,
I am looking for a CFG that will work with version 3.6 to tune MAF with STFT. The CFG I have does not work. Thanks. I have been away from the scene for quite a while and didn't realize the...
I had three MSD,(My Spark Died) coils fail within a week. If you tapped on them with a hammer, they would start to fire again, LOL. MSD would not stand behind them so I beat them with a hammer and...
Also wanted to add that I drilled the throttle blade. It came out of the box with no hole. When it idles, IAC counts are in the low 100's so I should be fine there.
I have the idle timing set at...
I have exhausted my efforts with trying to get this car to idle correctly. I have to give it pedal to start and it stalls most of the time, hunts, etc. I can get a semi decent idle if I bump the RAF...
Removing the filter fixed the problem. Thanks for the help!
Thanks. No, I was doing that just to compare. I am driving with varying loads.
I just realized I had the beta version until my PC crashed and I then reloaded the standard version.
Here is the config file I am using.
Here is a log file
I am not seeing data above 4300Hz on my MAF error histogram? Tried two different config files, same results.
I see values in commanded and afr from the wideband but not the error histogram>???
Here they are
Found it on the "other" forum. :burnout:
Here it is in case anyone else may need it.
I know the colors of the wires are purple and black at the tank. What pins are they at on the PCM?
I am doing some troubleshooting and want to ring the wires out for continuity, thanks, Zach
Checked wiring to crank trigger, tested good. Also checked impedance on the injectors at the PCM wiring and they all came in around 15 Ohms.
I will replace the crank trigger and do a CASE learn...
Should I go ahead and replace the crank angle sensor and check the sensor's wiring?
I am at a loss here. For some reason I started getting an SES light and found the random misfire code present. I have not made any changes to the car besides putting air conditioning in.
When...
Ok, here is what I did:
Installed and wired in the stock purge on the intake. Wired in and installed the vent solinoid so the PCM sees that it is there. I have it tucked under the dash. I wired in...
Hello,
I have a 2002 LS1 swap in my 94 Rx7 and I want to connect the EVAP solinoid.
Will the evap solinoid purge without the fuel tank pressure sensor? I planned to turn off the MIL codes for...
Thanks guys. that's what I thought. Should I keep the OLCL EQ ratio at 1.00 after 158 degrees after tuning too? Russ helped me in the past with my car when I was getting started and he left the ratio...
I think I am confusing myself here. :)
When tuning MAF, I should stay out of PE correct? But, will I hit the highest frequencies of the MAF table if I do not go WOT?
I commanded 1.13 in PE at...
Is there a way in H.P. Tuners to make the PCM run the fuel pump longer when turning on the key,(not starting the car)?
After sitting for a week, I need to key it twice to get the pressure up...