Thanks so much for posting!
I haven't had a chance to test yet but will update.
cheers
TIm
Type: Posts; User: timmilot
Thanks so much for posting!
I haven't had a chance to test yet but will update.
cheers
TIm
4270442705Hi Benno
Thanks for your input, I'm somewhat new at this so I'm going to ask for a couple clarifications.
1.) When you say delay the end of injection timing until the wideband stops...
42703thanks for looking. the later log was after I got the O2's working. I'm posting the latest log from a recent tune.
I'm richening the VE and smoothing it next.
4262642626
I'm adding the last log. I've got it in as the AEM wideband. I need to double check the gauge ground wire going to computer, I'd expect if they don't share a ground very directly,...
Thanks!
I'm finding I'll need a correction - the WB is about 2 ratio points high, i.e. indicating 16 at 14, etc. At least the WB gage seems to be at 14.7 when the NB's are at 0.5v approx. I did...
Ed, thanks again, this got me at least looking at the right area and found there wasn't continuity on the O2S low signal wire. Now I've got working NB O2's, STFT's going, etc., now on to getting...
Ed, thanks for the input.
I have LS3 injectors. It's running throttle by cable on an '02 Camaro computer.
It is a transplant, it's in a '95 RX7.
Front to back it's an 85 MM delphi MAF (5 wire...
I'm stumped as to why it's staying in open loop, or at least no STFT values since there are readouts of the two O2's. The rear cat seems to show up in the DTC's when I open them in scanner.
Also,...
Hello All,
I'm hoping to get some help with my current setup. I originally had the car dyno tuned and have taken to see if I can get it to idle around any better.
Specs: 85mm Delphi maf, L92...