which misfire tables would you disable \ and would this work with the vehicle( 2004 6.0 4L80e ) not running with the intension to listen for the TCC solenoid "clicking on & off". sorry, don't me...
Type: Posts; User: dansztoy
which misfire tables would you disable \ and would this work with the vehicle( 2004 6.0 4L80e ) not running with the intension to listen for the TCC solenoid "clicking on & off". sorry, don't me...
thanks Throttle
thanks for the replies everyone, I am trying to figure out how to get the tune info from my PC laptop over to the MAC computer which is what I have internet service on so I can attempt to download my...
strike that first reply, I did change the cylinder volume to .74999 each.
not very good at tuning. If there's not something obvious I missed that you guys can help me with I will see if I can get my tune posted in the morning. Thanks
didn't know their was a place in the tune to ID the cubes of the engine. Started with a 5.3 & changed to 6.0
Hi, I have a 6.0 project car(original Gen3 2003 pickup). Could use some help figuring out why my LTFT's are maxing out (+25) along with some STFT. The only other change made in the engine swap was a...
thanks for the Idea.
I guess I could have been more specific. If I can get a 0 to 5v signal from my egr or ac will the early HP tuner work with wideband. (without another interface). There are a couple of sources I can ...
Is the 0 to 5v signal to the wideband the only thing that hinders this idea from working or is there something about the early HP tuners (V.1.0) that will not allow wideband usage. I appreciate...
no, 9 pin at each end - thats it.
what do I need to enable wideband tuning with my set up? I have the Innovate LC-1 XD-16 on my 03 silverado pickup. I would like to make an attempt at some wideband tuning. What is the easiest way to...
I've sifted through some info in search , not able to understand which pin out from the pcm to go to a momentary switch. I have a pcm out of an 03 truck that had a "tow mode" switch on it. But in the...
thanks
I am a beginner tuner with "HP TUNERS VCM suite 1.0 . The tuner will not allow me to set the max engine torque above 640 . The same for the torque vs rpm vs gear tables. Appreciate some help.
clarify last line. What wire works what table.
Also the tables have option I'm not sure about. I have a single ele fan on my project. The table options are. Fan Type- 2fans/ auxfans/ or nofans. ?
next option is. Fan stage 1 on,off ...
I did find the ele. fan tables in "systems". Would appreciate answer to other questions. Thanks
I have a 2003 LQ4/Z car project with a reworked stock truck harness that retains the high & low speed fan control wires (ground sources?) from the ECM. My summit electric fan came with a relay that...
thanks for the Info.
excuse my ignorance, I believe (tcm) is incorrect . the control module that connects to gas pedal.
Hi, hoping to get some help on a throttlebody change. I have a 2005 6.0L lq4 engine/small magnuson 112 blower with a 75mm dbw throttlebody. I've made the physical changes (blower intake tube w/4 bolt...