Thanks guys. I got it. Readyness codes cleared and no SES lights. Should be good to go now!
Type: Posts; User: BADSZ28
Thanks guys. I got it. Readyness codes cleared and no SES lights. Should be good to go now!
I tried the MILS, readyness was not ready.
It was driven for a week after the flash. More than a week.
I'm trying to pass emisions. Trouble shooting.
I am trying to get my brothers 2006 Cobalt SS supercharged to pass emissions. He deleted the cat and his MAF is broken. I plugged in an SD tune but it's still not passing. The readyness codes are not...
I understand all this. Just trying to get some direction. Do I adjust 10% at a time, 50%...
Can someone give me a table that works for them?
I did see that and made some adjustments. But it did not seam to help. Anyone have a table I could try? Not sure how aggressive I have to be to see results. And I want it to be safe.
Is there a way to reduce it? I don't think I have too much timing in there. I basically modeled my timing tables from the GM Stage2 tune. Not agressive at all. And it has the stock pulley.
Should probably note this is for a 2006 Cobalt SS Supercharged.
No idea why. Seams to be the only place it does it is when I am off the throttle then go into it. Whether hard or smooth, there is KR. I attached latest tune and log.
Lnf?
Good to know. Thanks. I forgot the damn cable today. I will give it a try and run with it then. Hoping to squeeze out a GPM or two from my TBSS.
OK, after more reading I determined if I uncheck the automatic zoning, it does not change them. But after comparing the two files of equations, the changes are quite significant. Even though most of...
What part of the equations should be changed when you put the corrected VE back into equations? Everything changes for me. Including the RPM and MAP boundaries. Is this correct? I would think those...
Thanks.
What does that mean when I have the red star by the histogram tab?
I put in the stock values at 140* and below and that fixed it. Now it is way rich. Is there a histogram for logging AFR% error for OLFA table?
More stuff I am learning. I have looked at other VEs in the repository and did not see anything. So I should just continue to listen to what the AFR tells me then?
Cam only with typical BOs.
It just seams odd. I thought it was supposed to be smooth all across, not jagged with peaks and valeys. It just does not make sence to need more fuel at 2000rpm than...
I have been tuning the VE table for a while now. Lots of smoothing and tweaking over time. Every time I log, the AFR% error tells me to remove feul at 2400rpm at all loads. So what I get is a step. I...
I don't understand this comment. Can you explain?
I never thought ofthe OLFA table. I was messing with afterstart enrichment and not getting anything. I will try that and tailor it to my needs.
Thanks guys.
The car idles lean when I first start it. It does this for a minute or two and when warmed up it idles at stoich. Comanded reads right and even the IPW is the same as when warm. What is going on?...
Sent.
Tried both. Nothing. Still reads zero.
Can anyone help me?