They messed the scanner up
Type: Posts; User: 94SS
They messed the scanner up
Has anyone verified they work on these cars? The engine and trans have been swapped into a 57 Chevy.
Are you talking about the throttle clean reset?
Is their any parameters that can be added to the scanner that would allow you to see what the computer is thinking for idle feedback(integrators or PID learning)? And any other parameters related to...
Are any of the SRT-4 Neons part of the first release?
Is it possible to tune NGC3 computers with HP tuners if you want to use the beta software?
The 98 Vette after about 100 miles and a key off the message center started saying Pull Key and wait 10 seconds. That is with the Column lock set to not fitted and VSS to 255.
I used the switch on a 98 Vette to Not Fitted and it didn't disable the column lock. We used one of his aftermarket relays and set VSS to cut column lock fuel to 256MPH and it seems to work. Is the...
I found it under System>General>Column Lock. Is the 97-98 Vette going to be supported they do not show this parameter?
Where is it located in the BETA version?
Is there going to be a fix for the column lock issues the C5 guys are having?
The file still ask that you send it to support with 2.1.18 but it was read from the car with you previous version.
The original hpt. file I sent in still doesn't open but the one I got back labeled _fix does.
All I got was a file back named _fix last year. I just wanted to make sure I was ready so the customer doesn't have to wait.
If you have previously sent in a stock file for one of these that says Definition failed to load. Please e-mail this file to support at hptuners dot com Is it OK to do a full rewrite with the fixed...
Can you read these with HP Tuners or are you locked out and have to start with a fresh tune?
What are you using for voltages(0 volts 10AFR and 5 volts 18AFR)? And what works best for sampling rate with the LM-1? Thanks.
Which cam is that? I remember seeing something like that and somebody had already messed with the TB stop. I have never understood why the only way to lower IAC steps is to drill or crack the...
What effects do the first three columns of the VE table have on idle control if you are still using a MAF are they part of Desired IAC airflow? You would think since the MAF is still plugged in it...
Here's a good link that explained a little bit more for me.
http://www.hptuners.com/forum/showthread.php?t=1645&highlight=throttle+cracker+settings
Is it possible to get rid of the brief 300 RPM drop that you get when you put a A4 in reverse with a good sized cam. I have been looking through all the tables and it don't look like there is...
Anyone have problems with IAC trims? I had -.5 in Park so I took out .25 from your Running Airflow Table and then it shoots to the max of LTIT .5 . What is the cause of this problem?
I found this in the help file.
2 Bar MAP - Speed Density
This enhancement contains the following features:
2bar MAP sensor support (calibration capability for GM 0-5V linear MAP sensors) ...
Where do find good information to get started with the custom speed density tune I did not see anything in the help file?
How do you come up with the gm/sec values for the IAC park position vs. IAT or does it even play much factor in idle tuning? All I have heard is everything above 40 Degrees celcius make 21.