Hello,
we can support contact info below
Type: Posts; User: SultanHassanMasTuning
Hello,
we can support contact info below
post log so we can support
go ahead and email me and we can fix this issue
contact info below
lots of us can support, contact info below. we done several of them
your ecu has no VVT, how was the camshaft installed.
yes its no joke at all to make them run correctly
only with Uprev
you will not get the burbles effect that way
just commanding more fuel on decel wont do much
i see this ecm as similar to M139 for 2.0
best is to pull the file, we all can see if its modded or stock.
you will need to know which injectors, i think they come with 60lb siemens
the 2020 and up are considered GEN 2 and file size is also different
i remote daily, and support many on the forum. contact info below
SH7058 or SH7059
you can take care of it, email info and contact below
email me if you need support, tune needs work
upload your current factory file
you will need to invest, either buying 25K in MPVI3 devices or RTD to become a "reseller" dealer to enter and be part of the selected shops
contact info below
or get another mvpi and you can flash same stock file that you will need to license, "over write"
without seeing datalog and tune hard to see or tell the cause
looked like it was tuned by TDN device
even if you didnt save the datalog as save as flame log, its automatically saved in the HP tuners Folder by date/time
give this a shot, also log key on engine off to make sure your MAP sensor is reading 100KPA if so start
i dont believe its supported yet by most after market commercial devices
SIM2K-260 continental ECU
only supported by bench/boot setup