So I found out the TP Volts were reading too high and clocked the TPS accordingly. I turned off the MAF and LTFTs, DFCO, Cat over temp protection and began logging. Noticed I then had no IAC, closed...
Type: Posts; User: Twisted98
So I found out the TP Volts were reading too high and clocked the TPS accordingly. I turned off the MAF and LTFTs, DFCO, Cat over temp protection and began logging. Noticed I then had no IAC, closed...
After hours of reading and browsing the forums, i figured i would just make a post. I just finished my top end build with AFR 220s and Fast102/102 and 52lb injectors. It will start, but runs quite...
i removed it from the exhaust each time i calibrated it
I've had this software for awhile now, but i recently installed the NGK wideband sensor and module made a config and began scanning. I let the sensor calibrate for several minutes, took it for a ride...
Just want to say great information in this thread, its been veryyy helpful. One question i have is, when first tuning the VE, do you want to start with LTFTs if they are around or above 10, remap the...
Alright, thanks. I'll give it a try
The startup initial airflow table is 2.00g/sec across. it was from 0 at stock. It seems to start better, but it will still want to dip down almost to a stall.
Also the misfire tables are set to...
I've been trying to figure this out for a while now, and im having some trouble with getting this dip in the idle fixed. When i turn the car off, then turn it on it dips down to about 300rpm then...
Eagle, i attached my log and tune to my first post, maybe if you want to take a look at the histogram table in the log, you will see how much of a knock i was getting and you can see what im trying...
Thanks, but i wasn't really looking for a smart ass answer...i've searched in the forums and looked in the stickies and have yet to see the proper way of actually determining the right amount of...
anyone?
The information is now in my sig, im also trying to figure out how to adjust the idle timing so that it wont be missing all the time when its just sitting there, are there certain PIDS to put in the...
As i was logging the car on a test drive i noticed it started pulling timing, reaching close to 7.0 KR, and has the p0300 code. I haven't really started to tune it, just been logging some...
thanks alot guys
Hello everyone, I'm starting to get the hang of how to use HP Tuners, but now one thing that i can't seem to find anywhere, is how to save the data in the Histograms, whenever i load it back up and...
oops. forgot...Also, those that i have talked too said that a vacuum leak could be causing this, and every once in awhile you can hear a faint hiss when driving the car. As of right now i am spraying...
When the car starts up cold it reacts fine, but as soon as it warms up and i turn it off and turn it back on it takes awhile till it finds the idle again. Attached is the log on the warm up start,...