Disconnect the evap line to the manifold and put a vacuum cap on the inlet of the solenoid that's bolted on the manifold. Disable all evap codes that arise.
I don't know how but I was pulling...
Type: Posts; User: cobaltssoverbooster
Disconnect the evap line to the manifold and put a vacuum cap on the inlet of the solenoid that's bolted on the manifold. Disable all evap codes that arise.
I don't know how but I was pulling...
Evaporative. Mine failed in the canister and caused all sorts of problems
Try plugging the emissions port off.
If you tested a new maf then we should call it good. Ve is low but maf is high. To calculate ve you need rpm, tps, map in the lnf. Sub factor sensor will be iat2. So Verify Sensor Data Reports By...
I installed a maf backwards once lol yea it wasn't happy at all hahha. Is your waste gate or bov leaking at all? A small leak will cause fluctuations and lean trims.
right i hear yea on location. weird it does that after a base reset. any visual damage to your maf extension harness? do you spray methanol before the maf? (its not on your mod list but it is...
Did you re zero the base table when you re installed the maf.? Maf delete tunes have different Cal values by a wide spread
have you explored software issues yet? said you lost your logs and stuff. maybe you need a write entire factory file conversion again or a re-install of hpt suite?