here is my graph setup. I am no expert just tune on my own truck but everything I have read when ve tuning do I not want a commanded 1? I am commanding a 14.3 afr at 1 I had turned pe and dfco off...
Type: Posts; User: hrobb11507
here is my graph setup. I am no expert just tune on my own truck but everything I have read when ve tuning do I not want a commanded 1? I am commanding a 14.3 afr at 1 I had turned pe and dfco off...
ok probably dumb question got everything set up to scan lambda for now I have commanded lambda at 1.0 across the board. I am beginning to try and tune ve and I think I can use the pre loaded lambda...
it magically started working started reading with no description of the channel then I removed them all and for now its ok
sorry for dumb post
I haven't had a car to tune for a while now and getting back in the swing of things and I have looked and haven't found any definite answers. I installed a lc2 wideband and can log using their...
Have a 03 Silverado ss with new converter and getting the p0894 code. I did some logging engine rpm vs trans input rpm and that showed about 300 to 500 difference causing the code. The truck drives...
75k miles just installed small stall vette servo and trans go hd. goes through all gears fine when in 2nd if you go 50% throttle or more something is slipping clutches or converter don't know. I...
i bricked it because I had 1 bar maf enhanced in computer and built a new file using stock tune and tried a write calibrate I don't know much but I do know it was a bonehead move
may be dumb question but what can I check hardware wise to ensure I don't brick another one. the 2 files I have attached would be the ones I would want to swap. the new computer had all the same...
I can do a write entire even though they have different os numbers?
I have a 03 Silverado ss OS 12593058 bricked the computer truck was at work and needed to get it home bought one off ebay matching numbers on the sticker installed new computer used credits and got...
first I am a amateur tuner only tuning my cars I installed wideband through egr and set it up fine able to tune ve table with it. I am sure my answer is on here I just haven't found it but I am...
thanks guys I hate that I wasted the money on the interface but looks like I will cut it out and go from there
to my knowledge I don't have a amp fuse it is a non bose non onstar truck but I will look for a amp fuse
i am a amateur tuner just put a pioneer head unit in my 03 Silverado ss bought the chime interface and steering wheel control interface. ok now first attempt to write to pcm failed so I got on here...
ltfts should be disabled in tune and I reset trims prior to log but didn't turn them off I will give that a shot
here is my config is that helps
first I have a 03 Silverado ss bought hp tuners a few months ago felt like I don't my homework bought books dvds and read the fourm for hrs. ok had truck tuned without wideband to where stft were -1...
that was what I thought I am not a "pro" at tuning just wanted to make sure
thanks for help
purchased a lc2 innovate wideband for a permanent install on my 03 Silverado ss wired it to egr since I have no egr my question is I had to enable egr in my tune in order for any logging of it is my...
I am new got my wideband installed and I was pretty much on the money with air fuel ratio 14.3-14.8 I have played with timing very little but seems like when I add all I end up with is knock don't...
its a 03 Silverado ss lq9 cai shorties ported tb no cats and removed clutch fan have done very little to tuning trans that's next take a look you may laugh but give me ideas this tune was done...
like i said im a newbie but i am having a hard time finding the tune repository or how to access it
newbie here trying to learn I bought the calibrated success dvd wondering if anyone would share a mild lq9 tune with me trying to get good before I start changing parts any help is appreciated