I also turned on the tip in limiting I think is to drop power when downshifting. I do see KR when the rpm is dropping and also when changing gears some times. I'll see how that works :)
Type: Posts; User: Mario
I also turned on the tip in limiting I think is to drop power when downshifting. I do see KR when the rpm is dropping and also when changing gears some times. I'll see how that works :)
OK this is how far I have gone so far.
Less KR.
If gradually accelerate no KR if I floor it there is up to 3.
I do not go to far on RPMs till things start running smooth.
I do have an issue at...
Also I have been adjusting the STFT all week going back and forth from work I have been doing progress there as well :)
I just realized you wrote back I am sorry I am new to this site it will take me a while to get used to this lol.
I did end up doing a lot of reading and trying things out at low rpms and low load....
Questions
int Max exhaust Min = Accelerate commanded power ?
intake Min Exhaust Max = slowing down commanded power ?
Intake Max Exhaust Max = cruise commanded power ?
intake min exhaust...
ok question frame 10193 and up commanded lambda is 1 even though I am 3700 rpm and stays there till 5375 at 80 to 156 load.
???
538475384853849
Overbooster here I have the run 1 and run 2 the run 2 is from adjustments after run 1 on KR only subtract from the main tables.
the car is making lass power but I have less KR as...
MikeM does the original file look good to you?
here is a log file and also adjustments I made based on Overbooster5382853829
Hi MikeM I wish it was this easy for me to find some one close to take the car to.
I am in Toronto Ontario Canada.
If you know anyone that I could take the car to to have it done right I am all...
All the changes you recommended are done.
I got the KR histogram and I subtract what ever was recorded from all 4 main advanced tables (after they where all set the same)
I think I'll flush this...
Thank you very much for the info like I said I do not know how to tune this is a tune that I got from a shop they where saying that there is nothing wrong with it and its just my fuel.
I do not want...
I am missing a few of the pids or sensors I believe I will make a new one with them on.
Should I make any histograms specific?
or should I have all the info running on the charts?
thank you
thank you for the quick response.
here are the files.
Hi all I am having tons of knock up to 8 degrees.
I have a full build motor and running the ZFR7163.
I can see up to 42lb/min.
I am not a tuner I am just a mechanic.
Any help will be appreciated....