From what I can tell it happens every time I change the axis to match what I use with 2.24 & bluecat tool. I just tried it with the default axis and it calculates fine.
Columns:...
Type: Posts; User: b2009v
From what I can tell it happens every time I change the axis to match what I use with 2.24 & bluecat tool. I just tried it with the default axis and it calculates fine.
Columns:...
Installed fine for me but after smoothing the VVE and trying to calculate coefficients I get "Index was outside the bounds of the array." error.
Each of the physical injectors have a number marked on them, I think the plug, that corresponds to the injector # on the flow sheet.
Goto Transmission/shift properties/shift time
It adds time in seconds to the shift based on engine torque, higher torque shorter desired shift time, lower torque you add more shift time.
I've...
Add shift time to the 1-2 shift in the range that it's too abrupt.
There are a number of TM PID's you can log to see which one is active and what it is using for control.
Being an A6 my guess would be thats your Transmission TM kicking in if there was a...
What does your pcm commanded afr show in the 2-3k range?
A while back I created a histogram for mafs ve error, basically spits out the error percentage between the two. The histogram is identical to your regular wbo2 ve error histogram but calculates the...
Same here.
After playing back a log it is there initially but as soon as I use the slider to speed through the log the frame by frame vertical line disappears.
I can play the log again and it...
COT will certainly cause a similar situation.
should be under vcm controls fuel & spark, at least for gm it is.
maybe check under tm/supercharger/boost disable, map disable kpa
stock is 192kpa
Been using the MPVI Pro for a little while and decided to use the NGK AFX wideband setup.
Found the install information all around, yellow wire to eio input terminal #1/top and brown wire to...