Russ K is right on the money! Worked great for me.
thanks
Type: Posts; User: gtpthriller04
Russ K is right on the money! Worked great for me.
thanks
i have a AFC 2.2, its not hooked up yet. How do i scale the MAF down?
What happens when the MAF goes over the 11500? I have noticed that after that point the LTFT locks in at 0 no matter what.
...
i am having the same issue! any advice would be great!
Hey,
thanks for the response. I am running a stock L67 MAF. I finally figured out my issue with the bogging under boost, the MAF was maxing. I adjusted it to 16,000hz, no more issues.
I have...
i finally was able to get a good scan on my MAF and i noticed that my STFT where -12/-25 past 5K hz. how much do i change those numbers to get the numbers closer to -10/+10?
thanks
Hey,
I recently swapped my N* TB n LQ4 for a stock L67 TB. Can someone take a look at the scan and tell me what you think? Also i did notice me TPS sticking, i would have the pedal released but it...
Ok i just replaced my LQ4 and a leaky injector O-Ring on my 01 GTP Turbo, but my LTFT are -22.9 under any kind of accleration. The only code that comes up is P0300, 174 (rich in bank 1). When i try...
i am also having the same issue.
thanks
does anyone have a file that i could use for my 01 GTP. I have the following mods. I do have a AFC 2.2 that is remotely wired if someone uses that too.
42# injectors
LQ4 MAF
Z7 turbo kit
ST1...
Can someone post their TCC min/max and apply/release speed settings. I have have an issue with my TC locking and unlocking in third gear. I tried raising my tcc min by 20% and also added MPH in third...
hello,
my engine surges once im crusing and it shifts into 2nd and i believe 3rd. anyone deal with this? would this be a trans thing or a engine tune thing?
thanks
Hey guys can i have someone look at this tune and tell me what you think. I had a little surge in the idle that im trying to get ride of. This a GP with a NIC cam.
thanks
hey can you guys take a look at this tune and log and tell me what you think?
I have been having issues with it hesitating when i try to acelerate.
thanks
Can anyone take a look at my log and tune to see what i need to change?
I really appreciate it!
Charles
Anyone have an idea
Yeah it hasn't changed
Hey,
Sorry it took so long to get back to this. i had to wait to get a N* TB IAC, those things are stupid expensive. Luckly i found the whole TB for 75 bucks.
Here is where i am now;
...
I will have a log posted up tomorrow evening, as long as i can get the new IAC taken care of. The only reason i figured i needed to run OL was because many other peolpe with the same cam ran it that...
Can anyone look at the tune i posted and see if there is something i can improve?
thanks
I will hopefully have the new IAC in tomorrow, that should fix the surging issue. As for the hesitation im guessing the MAF tune is off, and i have no idea how to even know its right or not.
Does...
Sorry, here is the tune. I will post the scan later
thanks a lot
How do most peolpe post their tunes? Sorry im new to this.
Also my issue is now the hesitation when i try to accelerate. I found that the surging was from a bad IAC, which i had replaced once...
Once again i am having drama with my GP. I need some advice/ insight on what could be my problem.
I have NIC cam, i recently had it tuned but it still is not running correct. When i start the car...
I am having the same issue, i thought it was more related to my MAF but it seems to be operating correctly. Also, my cars tends to stall at times.
My car likes to stall when i shift it into D/R, this didnt happen till i installed the CAM. I have been told that it is caused by the VE tune. Can anyone give me some tips on how to tune this table....