Hey, sorry, been recovering from the flu. Here is my tune that is still a work in progress. Please feel free to comment on anything about the tune. Are you using the old HP 2.24 version or the...
Type: Posts; User: hvymtllvr
Hey, sorry, been recovering from the flu. Here is my tune that is still a work in progress. Please feel free to comment on anything about the tune. Are you using the old HP 2.24 version or the...
Injectors are performing great, about 65% duty cycle at WOT.
Sorry, I was referring to the help in HP tuner, "Your new injector flow rate will be calculated automatically. This rating is for 0 VAC." Thanks greatly for the file! I will input that data and go...
Hello again, I'm still working on tuning my LS1. Started from scratch as you recommended and found some of my set up errors. Changing fuel pump and cracking open throttle 2% really helped out with...
I hope I'm on the right track here. I'm using the fuel trim method this time which is much easier and I seem to get better results. I dialed in my wideband better (bosch LSU4.2). The run file...
LOL, don't answer that. When I installed the wideband last year I did a fresh air calibration on my gauge, never did it on HP Tuner. Using the Bosch LSU4.2. Will do that next and log a run. I am...
Ok, with that said I have a question. I put some miles on it in normal non tuning mode to see what my trims would do. After settling down with little or no STFT going on, I noticed that my wideband...
If normal driving looks good, should I just make adjustments in the PE multiplier table for WOT to get the AFR correct?
Ok, sorry it took so long. I flashed your attached tune and here is my warm up and basic low RPM driving scans. What do you suggest doing from this point?
Will do, and thank you very much for your time. The cam specs are 226/236 .525/. 525 110.
Horrible? Dang! Here are my my mods to this LS1 WS6 M6. Airbox, long tubes, larger rear pipe with flowmaster 40, ASA cam, LS6 springs, LS2 chain. It idles great from cold start, comes off and...
Hello :hi:, this is my first HP post. I've been using HP for over a year now with upgrades here and there. My most recent upgrade was a cam install on my stock LS1. I've done the AFR, MAF, and...