Search:

Type: Posts; User: C10Vortec

Search: Search took 0.00 seconds.

  1. Replies
    1,731
    Views
    1,047,225

    Has their been any updates on the availability of...

    Has their been any updates on the availability of RTT with 3.0 yet? thanks
  2. Well I think I answered my own question. I tried...

    Well I think I answered my own question. I tried to find a matching OS to include the custom 3 bar SD setup with a 4l80e. Found one over at sloppy mechanics and went through the segment swap and the...
  3. In the process of swapping to 4l80e tranny do i need a segment swap?

    c10 3bar custom OS have a harness with a pigtail for 4l80e. My editor has all of the trans calibration settings, but cant figure out if this is for a 4l60e or 80e? My tranny ID is 9358180 CVN is 10e7...
  4. I am going to try and verify tomorrow, but that...

    I am going to try and verify tomorrow, but that was one of the reasons I got the base tune I did was that stuff was set up already...
  5. 5.3 cam/80lb injectors/ turbo Need help getting idle set

    So I just got my VCM suite in the mail and had to give it a go. I got a base map from JSRacing products who had a similar setup injectors etc. The motor will start up and then sputter erratically...
  6. Ok thanks i will see what i can figure out making...

    Ok thanks i will see what i can figure out making some changes...
  7. 98vortecSilverado got it thanks, i do have a...

    98vortecSilverado got it thanks, i do have a wideband i'm planning on tuning with (innovate i believe), i am just curious how to start due to the fact that it only idles for a few seconds and i may...
  8. 5.3 vortex turbo base map adjustment for altitude

    Hi,
    I just ordered HP Tuners Pro and and reading up on my options to proceed once its hear. My setup is a gen 3 vortex 5.3 with a 76mm turbo, 80lb injectors, LS1 intake, cam etc...(in a 1972 c10) I...
Results 1 to 8 of 8