DAM! I have a lot more things to mess up now. Thanks guys!
So are there any limits to adjusting these switch points?
Type: Posts; User: streetlegal
DAM! I have a lot more things to mess up now. Thanks guys!
So are there any limits to adjusting these switch points?
Hmm. Ill give that a try when I get home.
The latest beta. I had to get an upgrade a couple months ago to be able to tune a G8GT.
On the left side of that tab I have:
Open Loop
EQ Ratio.
STFT open Loop enable/disable.
Nothing else below that.
I have seen what you are referring to in a screen capture on this forum...
All I see is O2 rich/lean vs airflow- Bank 1 and Bank 2. Click on on of those and I have O2 sensor B1 R/L vs Airflow Mode plotted in rich/lean O2 sensor voltages.
I see that but what is defined as...
Here is one of the tunes. Not the latest but the only one I have on this laptop. My dumbass cant find the airflow mode table.
So airflow mode isnt a table in the editor I thought I was overlooking, it would be a histogram in the scanner I have to set up. Well you wouldnt happen to have a "How to for dummys" on how to do...
It actually is in open loop at idle then closed loop above 1200 rpm. I just would prefer it to be in closed loop. When the wide band is reading at stoich, the NB O2 sensor voltages are around 800mv....
Oh it does fine till I go closed loop. I almost wish I would have gone with manifolds instead of headers this time around.
Hello everyone! I havent posted in a while but I have a question. I have an 02 Z28 with an LS3 in it now and I have idle fueling nailed down where I like it and right at stoich with a wideband in...