Thanks for sharing.
Type: Posts; User: gsegse
Thanks for sharing.
http://www.hptuners.com/forum/showthread.php?t=13593
^
stock auto 05
yes ... write entire
did you write calibration only or write entire ?
your PE delay rpm set to 5500 rpm . so your pcm commands stoich ( 14.6 afr ) up to 5500 rpm
set it to lower number to hit PE mod ... like 3k or lower
Same
http://ls1tech.com/forums/conversions-hybrids/312119-ls1-swap-faqs.html
http://www.hptuners.com/forum/showthread.php?p=109682#post109682
maybe you are not hitting PE mode. some 2006 turcks have to 0 out pe enable same the att. pic.
your timing tables are high for 55cc and flat top piston with pump gas .
i had the same befor...
back to stock tune and flash it again for 2 fans setting .
http://www.lt1swap.com/cable_conversion.htm
http://www.lt1swap.com/2000harness.htm
http://www.hptuners.com/help/demos/160%20Thermostat.swf
WARNING!!!
Some guys fried there pcm after changing desired throttle area tables( DBW ) .
do some search and you well find the thread.
thanks
Hi guys … I want to remove may 4l80 trans from 06 truck and put 4l60.
any one got the swap wiring conversion.
Thanks
Pic attached allowed you to enter PE for 05,06 truck .
Russ k explain that before.
Thanks
use the ls3 inj data
http://www.hptuners.com/forum/showthread.php?t=33472
attac..
0 out your maf table . air flow .....General .... Air flow Vs frequency
http://www.hptuners.com/forum/showthread.php?t=30431
Thanks guys for the respond , problem solved I just increased the low area and the code is gone .
Hi.. I have P106 code after upgrade from 00 to 02 OS.
I have no code before I upgrade, so do I have to check the map wires or tweak the tables of the map sensor in the att pic.
Mode:
TM M6 fast...
For p0121 try the link below ( max map 100 kpa and min map 0 kpa )
http://www.hptuners.com/forum/showthread.php?p=101510
If you removed yor cat's put the DTC to #3 no error report, If not try...
It is not plug and play. tray the att. files then you need the fuel segment .
http://www.hptuners.com/forum/showthread.php?t=13927
Thanks
http://www.hptuners.com/forum/showthread.php?t=8917