Cylinder charge temp bias table.
Type: Posts; User: blown 04
Cylinder charge temp bias table.
im going to lower my tps value to 35 . has anybody seen where there are time pe don't work? im going to try my buddies x link just to eliminate that.
?
looking over some logs trying to solve a lean spike on throttle transitions I found a few times where the map and throttle values were reached but the commanded never changed from stoich. but other...
.048 I meant
0.48 x 31.124308 = 1.49
Is that 1.5 what you see at idle or on deaceleration?
so this can help with a lean tip in? im dealing with that issue also. I might try to increase that value to help with the lean condition. I cant feel it but my wideband shows it. when I lowered the...
Is there a way to properly set this value for the injectors you use? I have searched but can't seem to find answer. I'm running Dekas 60's and my stock value was .028. My pulse width is 1.9 1.8 at...
Not sure. Downloaded it when it was first released. I emailed support about if I needed a newer version of 2.24 or I have to have 3.0 or do I just pay for the credits. Should it be free in 2.24?
Im still using 2.24 and trying to go speed density. when I go to write entire it wants me to buy more credits. I thought this was free with 2.24
do I have to have 3.0?
Im going to try and unhook my bank 2 rear o2. I have them turned off in the tune. Cause I have my wideband. We're bank 1 rear o2 would be. Could this have a effect on the way the fronts work, because...
Yes idle and light cruise. I was thinking about a cat issue? I was going to drop my y-pipe from the headers and see what happens. But that might screw o2 readings also if air gets sucked back up....
Always bank 2 is the leaner bank or the bank with the higher trim values
Thank you I forgot to mention that I have replaced gaskets with new stock MLS a few times. Best I can tell no leak. But I will be checking again.
Im looking for possible causes for my trims being off bank to bank by as much as 6% sometimes more. This makes it impossible to try and dial trims in close to zero. TVS2300 came with marine Delphi...
I PM'ed you
can someone please look over my tune and help me get a slight cruise control issue im having? Truck will slow down but happens very slowly, gets real slow around 30mph and less. I have made some...
I know im suppose to post my tune when asking for help but I just installed deka 60 injectors and used my Banish dvd for the data so I don't want to post his
info without permission. I have a 6 to...
I have been reading on here that some people zero out the cracker table. What exactly does or will that do? This problem occurred when I installed my ls3 throttle body,
ok I will give that a try. First I made follower decay and cracker airflow tables back to stock. still seemed like it wants to stay going, this is worse from 0-30 mph. like I said I have worked on my...
can you please enlighten me on what you see wrong with these tables? I thought my cracker airflow was stock but I did raise the decay table some. sorry for my lack
of knowledge in this. should I...
Ok been working on this tune for a while now and im wanting some advice on what I need to improve on. Just installed long tubes on truck with
single 3'' exhaust system and I feel I lost power over...
Anyone? I know someone here can tell me how screwed up my tune is. this truck to me is not performing well at all. how can I get a more smooth running engine? as soon as I richen up the AFR the...
what are your engine specs?
here is a short log its not much but at least it shows that everything seems to be normal, o2s are moving, yes my bank 1 trim is slightly different from my bank 2. im starting to wonder about my...