Been using the FAST system for a while now and just ordered a new LM-2. Will give you my opinion after a week of use.
Type: Posts; User: Tunning @ LMR
Been using the FAST system for a while now and just ordered a new LM-2. Will give you my opinion after a week of use.
"Spark Minimum TqMgt"- if you set entire table to 5 or 8 and tq mgt is still active this will be the lowest amount of spark engine will see during part throttle shifts or WOT shifts. It is the hard...
Just ordered a new LM-2. Surely there are more people that have it working 100% than just the few in this thread. Really that many issues?
As soon as I take delivery of ours you will be getting the file. I find it hard that GM would lock them considering the market for GMPP. Time will tell.:drivin:
Steven Fereday
Any support for theses yet ??
We use the tailpipe for quick pulls to display on dyno file, I have a precat fast wide band that gets connected to laptop and interfaced into hptuners for tuning.
Any updates on 2011 ford stuff???
Does anyone have a stock file for a 01 gmc yukon denali xl ?? I looked in the repositiory and there is not one listed
Junk converter clutch. I have a 2010 camaro with the clutch locking up at wot that has no problems. This car makes 1000whp and weights 4000lbs and runs mid nines in the quarter.
I have an 07 saleen with a kenne bell blower that was brought to me to tune, I am having problems with the throttle body calibration. It surges at low throttle, and has a hanging idle when it first...
Does anyone know what wire (the tach wire coming out of the pcm) is on a 09 5.3 gmc sierra, say the wire for hooking up a window switch for nitrous I have tried some of the local dealerships and the...
I have one here now that is an 09 gmc sierra but it came from the factory with 4speed auto. It will be hard on a truck with a 6 speed auto for sure. 440lsx with 4l80
I did the ect vs startup ect, and the delay table is maxed, and the L trim ect enable is set 283, 284. But the short term trims stil work. I will try the maxing the O2 readiness ect table.
Any way to make 05 and up car run with no trims in open loop? I have the car in open loop now but the short term trims are still messing with my part throttle air fuel. Its a race car.
Thanks for helping me figure it out
thanks for helping me figure it out
No new scanner does not fix.
Anyone have a scanner that works on an 08 mustang gt?????????????
We did an 2010 camaro with the dod and had very good results manipulating these tables
No there was no change with the cylinder volume, I understand that you are try to learn. I have been tuning ls stuff for several years and I learn new stuff everyday. That is why i posted this...
Yes this is Joe Stil having problems with this car have tried everthing. Tps voltage is .64. The pulse widths are not that small 2.0ms in neutral, and they rise to 3.2ms in gear but the car is stil...
anyone have correct info for 79lb racetronics injectors, voltage offsets and such????
Good point I did not think about it that way, thanks. I have a lot going on and some extra eyes always helps.
Why would you run a car that make 850whp at 12.8 air fuel on pump gas. And the idle region on this car is 75kpa and higher. I will fix the boost pe, but I know it will not effect the idle.
Here is the file