Search:

Type: Posts; User: agentruley

Search: Search took 0.00 seconds.

  1. So I replaced MAF and got ahold of another 4.8...

    So I replaced MAF and got ahold of another 4.8 truck and compared readings, MAF is good. Smoke test is good. Not a vacuum leak but maybe bad injetor? Or low Fuel pressure? (Or O2 SENlSORS are reading...
  2. Anyone else take a look at my logs and see if you...

    Anyone else take a look at my logs and see if you can tell if it was a bad MAF. vacuum leak or bad injector....
  3. Nah, I am going to exchange my current MAF for...

    Nah, I am going to exchange my current MAF for another one but I am still going to keep the 1BAR sd tune for now because it runs so darn good.
    I will tune the VE when I figure out how, but now I...
  4. And then compare that run to the cold/MAF tune...

    And then compare that run to the cold/MAF tune run I did earlier this morning
  5. Good advice man, but screw the MAF. Engine is...

    Good advice man, but screw the MAF.
    Engine is stock, and the changes were made by the last person?
    I loaded the stock timing tables and VE tables and then set the computer to never go below 18...
  6. 4.8/t56 3.42 rear end 255/65/16 tires I know the...

    4.8/t56 3.42 rear end 255/65/16 tires
    I know the vehicle speed thing is off
    The reason on why I am just so paranoid about this was because in the winter, I would start it up, and it would missfire...
  7. 1995 OBS chevrolet truck. I have the MAF right...

    1995 OBS chevrolet truck.
    I have the MAF right at the throttle body after a 90 degree elbow.
    You say there is no KR but I see on the histogram the red line that is KR and it is quite frequent of a...
  8. So I did the smoke thing, no leaks? But I did...

    So I did the smoke thing, no leaks?
    But I did unplug or 'fail' the MAF and ran it on just the MAP, and for some odd reason, it seemed a bit more peppy. It keeps getting faster and faster.
    This is a...
  9. Ok I understand that. But what I dont understand...

    Ok I understand that. But what I dont understand is whats making it lean. Is it the tune thats making it lean?
    Is it an injector or vacumm leak and if so how do I determine the difference in between...
  10. Switched sensors on the sides and did another...

    Switched sensors on the sides and did another run.
    I don't know what to say.
    How come both the sensors read differently when the engine isnt even running?
    Something is funky.
    So here is another...
  11. Ok. I understand. Could the o2 and FT readings...

    Ok. I understand. Could the o2 and FT readings also point to an injector that is always lean?
    And so know do I need to replace said sensor?
    or both?
  12. I keep trying to add timing persay (but really...

    I keep trying to add timing persay (but really keep disabling things that take away timing) and it keeps running better and better.
    So I did a few more runs, here is a log and the change in the...
  13. Just started finished engine swap, trying to tune 4.8 (wont run right)

    The engine just doesn't feel right.
    When cold it misfires hard then after it warms up a little bit it magicly runs a lot better (that was a month ago)
    Finally able to drive it down the street,...
Results 1 to 13 of 13