Search:

Type: Posts; User: 1gr8ate

Page 1 of 2 1 2

Search: Search took 0.00 seconds.

  1. Wondering it you ever cured the rev limit issue....

    Wondering it you ever cured the rev limit issue. I'm running into the same issue with very similar set up but in a boat. limiters set to 6400 but only climbs to 4850 then won't go any higher.
  2. Probably a dumb question but does it matter the...

    Probably a dumb question but does it matter the tune axis are switched? I've been having issues with a 99 5.3 80mm turbo e85 80lb injectors 2 bar sd my 12350 table looks nothing like this. I've...
  3. Replies
    70
    Views
    44,619

    Who's Ed? And where would I find what he does

    Who's Ed? And where would I find what he does
  4. Replies
    17
    Views
    29,150

    Kinda a old thread but trying to do this on my...

    Kinda a old thread but trying to do this on my next book ares tablet. Ive down loaded the drivers and 3.6. Yet still tells me cant open the file, am i doing something wrong?
  5. Replies
    24
    Views
    7,917

    I really appreciate all the help guys!

    I really appreciate all the help guys!
  6. Replies
    24
    Views
    7,917

    Yes I got it to fire off finally the coil plus...

    Yes I got it to fire off finally the coil plus weren't making good contact for some reason pulled them on and off a few times. So its in the relocation coil extensions not the PSI harness but I did...
  7. Replies
    24
    Views
    7,917

    Your right on that one I didn't check the pin out...

    Your right on that one I didn't check the pin out just ohm'd the wires. That's a good catch i hadn't thought of, Thanks man..
  8. Replies
    24
    Views
    7,917

    Did the write entire can't do the crank relearn...

    Did the write entire can't do the crank relearn yet don't want to rev it to fuel cut off right yet.
  9. Replies
    24
    Views
    7,917

    Sure!

    Sure!
  10. Replies
    24
    Views
    7,917

    Now it's giving me crank position sensor A...

    Now it's giving me crank position sensor A circuit po335 and ideas why I just changed the sensor to a new one
  11. Replies
    24
    Views
    7,917

    It had the right one it was grey but I went ahead...

    It had the right one it was grey but I went ahead and changed it out cause it just made more sense while I was there. And another write entire and it fired for a very few seconds but that's more than...
  12. Replies
    24
    Views
    7,917

    Ok Thanks I'll check it for sure.

    Ok Thanks I'll check it for sure.
  13. Replies
    24
    Views
    7,917

    I believe the sensor is black but I'll check...

    I believe the sensor is black but I'll check again when I get off
  14. Replies
    24
    Views
    7,917

    All wires ohm'd great from connectors to ecm/tcm...

    All wires ohm'd great from connectors to ecm/tcm to fuse block. Could the ecm just not be excepting the vats patch? Is there another way to go about this?
  15. Replies
    24
    Views
    7,917

    OK I see.. Still wont start.:confused:

    OK I see.. Still wont start.:confused:
  16. Replies
    24
    Views
    7,917

    Already disabled in the attached tune. I believe

    Already disabled in the attached tune. I believe
  17. Replies
    24
    Views
    7,917

    No injector pulse no spark won't start. Has power...

    No injector pulse no spark won't start. Has power to everything just no fire out of the coils or ground pulse to injector. No codes. Already made sure the ecm maintained 12 volts while cranking...
  18. Replies
    24
    Views
    7,917

    Help with 1958 Impala Gen4 LS Swap

    Guys, can you give me some input here, I've read and done everything the forum says as far as deleting vats all the key immobilizers with all the emissions stuff. Here's what I have gen4 5.3 799...
  19. Replies
    2
    Views
    2,452

    Great Thanks!

    Great Thanks!
  20. Replies
    2
    Views
    2,452

    Swap L83/6L80e tuning

    Swapped a L83/6L80e into my 71 swb c10 can i tune out the fuel pump module and just run just using a regular fuel pump?
  21. Replies
    166
    Views
    80,737

    I have the NGK/NTK wide band has it been...

    I have the NGK/NTK wide band has it been implemented in yet?
  22. Had the same issue in a truck i built during hard...

    Had the same issue in a truck i built during hard acceleration the battery would tip back and ground the positive terminal on the inner fender.
  23. OK i turned off the po300 last night and it will...

    OK i turned off the po300 last night and it will lock up in every gear like it suppose to but not in 6th? I just changed these cells and will be trying this now. Thanks i hope this works
  24. I don't see a misfire table I do get the random...

    I don't see a misfire table I do get the random po300 misfire code though. My tune is attached at the top here if you want to peak at it.
  25. Sorry but I'm not following what your saying, I...

    Sorry but I'm not following what your saying, I don't have much experience with it.
Results 1 to 25 of 30
Page 1 of 2 1 2