Search:

Type: Posts; User: 376FD

Page 1 of 2 1 2

Search: Search took 0.00 seconds.

  1. Replies
    4
    Views
    1,409

    Mine is doing the same thing, I can't connect to...

    Mine is doing the same thing, I can't connect to any vehicle after doing the 4.10.5 update.
  2. Replies
    5
    Views
    3,251

    The Maf was in backwards, and the E39a ecu ran...

    The Maf was in backwards, and the E39a ecu ran noticeably better, still no vss but it runs like a champ.
  3. Replies
    0
    Views
    617

    160% throttle request

    I have a L33 running in a '87 RX7 with long tubes, LS6 intake/injectors and otherwise stock. It runs great but when I push the gas pedal down all the way (factory chevy dbw pedal) it will read 160%...
  4. Did you ever get this figured out? If it will...

    Did you ever get this figured out?

    If it will run on starting fluid then you aren't getting fuel. Make sure you have good pressure at the rail, if not check your fuel pump. If the injectors are...
  5. Replies
    0
    Views
    725

    '03 P59 throttle at 150%

    I'm swapping a 5.3L L33 into a '87 RX7 and after getting it all wired up and plugged in I got a surprise: I hooked up to the ecu and found it shows it's from a '03 Tahoe. It starts and runs just...
  6. Replies
    7
    Views
    4,372

    Do you mean how long it cranks before it starts,...

    Do you mean how long it cranks before it starts, or how long it will run after starting with remote start?
  7. Replies
    4
    Views
    2,108

    the .hpl file in the first post should have been...

    the .hpl file in the first post should have been correct but it may have been corrupted. Try uploading that one again, the second file is just the layout file and not the log. It seems the big...
  8. Replies
    4
    Views
    1,937

    Have you thought that maybe the engine is just...

    Have you thought that maybe the engine is just running lean and your o2 sensors are working normally? Can you get the O2 sensors to read by revving?
  9. Replies
    4
    Views
    1,937

    Correct, the E39a uses a can signal for VSS so it...

    Correct, the E39a uses a can signal for VSS so it reads 158mph at all times, but even with that the issue the e39a ran better than the e39. There may be tables that we don't get to see or play with...
  10. Replies
    4
    Views
    1,937

    I would check battery voltage at the pink/black...

    I would check battery voltage at the pink/black wire with the sensor plugged in and key on. The heater shouldn't have anything to do with the ecu unless you have the ecu turning on the relay. The...
  11. Replies
    2
    Views
    2,369

    You can also go into the Engine Diag tab, then...

    You can also go into the Engine Diag tab, then Exhaust and turn off the catalyst test and the post O2 test. This will keep the ecu from even looking at the rear O2 sensors. Did you ever get the...
  12. Replies
    5
    Views
    3,251

    Got back from the track and got to do some more...

    Got back from the track and got to do some more playing with it, got the VSS working but it only works on the e39 ecu, not the e39a. Both ecus will give me full rpm but not full throttle. The two...
  13. Replies
    5
    Views
    3,251

    I'm actually trying to keep it as stock as...

    I'm actually trying to keep it as stock as possible to eliminate issues like that that. It's a factory pedal and seems to read properly, it gets to 99.6% which is close enough for me. No CEL, the...
  14. Replies
    5
    Views
    3,251

    Torque management oddities

    I'm tuning a track only Mazda MX5 with a LFX/6spd manual swap that is a bit of a mess. The engine and harness are supposedly from a 2014 Camaro, the ecu is from a 2012 camaro and the intake and...
  15. Replies
    11
    Views
    4,790

    Got it all sorted out, turns out we had the...

    Got it all sorted out, turns out we had the throttle pedal from the wrong year. The engine and TAC were from '06 and while we ordered a '06 pedal the part numbers didn't match up. I already had...
  16. Replies
    11
    Views
    4,790

    Did you swap harnesses or just do some rewiring...

    Did you swap harnesses or just do some rewiring for the cable throttle?
  17. Replies
    11
    Views
    4,790

    After several emails with support I'm no better...

    After several emails with support I'm no better off. They have no idea, told me to try a TAC module as that's what usually goes bad. A new TAC module and a new pedal later and the symptoms haven't...
  18. Replies
    11
    Views
    4,790

    That was the conclusion I came to as well. I...

    That was the conclusion I came to as well. I sent them an email this morning. :)
  19. Replies
    11
    Views
    4,790

    I swapped all the throttle settings to the ones...

    I swapped all the throttle settings to the ones from the 4.8 tune and no difference. I can reflash with the original 6.0 tune and throttle works fine till it goes into limp mode like it did before. ...
  20. Replies
    11
    Views
    4,790

    I couldn't get it going and couldn't figure...

    I couldn't get it going and couldn't figure anything out so I downloaded a tune for a '04 4.8L truck that came with a manual trans and changed all the fuel/airflow tables to match the 6.0. It fired...
  21. Replies
    11
    Views
    4,790

    Okay, I have a little update. It looks like it's...

    Okay, I have a little update. It looks like it's transmission related. Or lack of an automatic transmission at least. It seems to be going into limp mode but it doesn't throw any codes and I can't...
  22. Replies
    11
    Views
    4,790

    Jeep loses throttle

    I swapped a lq4 from a 05 chevy truck into a '81 jeep scrambler and it seems to start and run fine but the problem is that if I start it and just let it idle without touching the pedal for 10-15...
  23. Replies
    4
    Views
    2,072

    Thanks for the replies guys, I've been logging my...

    Thanks for the replies guys, I've been logging my trips to work (~6miles) and then doing a little playing at night. Unfortunately I don't have a lot of time but I seem to be working in the right...
  24. Replies
    4
    Views
    2,072

    The engine is stock internally, I swapped to a...

    The engine is stock internally, I swapped to a LS3 intake and injectors and am running a credit card style maf as well. Other than that I just have a free flowing intake, long tubes and full exhaust.
  25. Replies
    4
    Views
    2,072

    Low load tuning with stock O2?

    I have a '93 RX7 with a L92 from a '07 escalade and a T56 manual trans and the car runs/drives pretty darn well. I've gotten high load A/F sorted on a dyno, with the wideband in the tail pipe, but it...
Results 1 to 25 of 31
Page 1 of 2 1 2