Search:

Type: Posts; User: burners

Search: Search took 0.00 seconds.

  1. Replies
    5
    Views
    2,486

    Thanks for the response, Bill. Last night I...

    Thanks for the response, Bill. Last night I started doing just what you suggested. The only problem I've encountered is the resolution in the area that I need gets a bit imprecise.
    2.42,14.750 ...
  2. Replies
    5
    Views
    2,486

    The graph doesn't do a good job of displaying...

    The graph doesn't do a good job of displaying what is going on but the table certainly does. Here, I have put them side-by-side to show what is going on. It skews the entire table so that it reads...
  3. Replies
    5
    Views
    2,486

    User defined input voltage resolution?

    I have this posted in the EIO section but nobody is responding.

    I'm trying to setup a NGK WB that has a Holley controller. I have the voltage/AFR table from Holley and I put that into the "list"...
  4. Replies
    0
    Views
    1,719

    User defined input voltage resolution?

    I'm trying to setup a NGK WB that has a Holley controller. I have the voltage/AFR table from Holley and I put that into the "list" table in the configure user defined EIO window for my PID. The...
Results 1 to 4 of 4