Ok did some research and asked previous owner about the fuel set up for this car, fp is a walboro with a hotwire kit and the rails and injectors are those out of a 2000 corvette if this helps any, I...
Type: Posts; User: 97ls1swap
Ok did some research and asked previous owner about the fuel set up for this car, fp is a walboro with a hotwire kit and the rails and injectors are those out of a 2000 corvette if this helps any, I...
You know I was looking over that today and I thought they looked weird.
I changed the plugs today and loaded the tune as suggested but then it wouldn't idle at all, so I converted back without the last changes made in the last post and it would idle again, still rich...
Well havn't been able to do much, the storms and tornado's keep rolling in here, It has now fouled out the new set of plugs after one warm up and a few moves around the shop
did you put this 98pcm on a 98 or latter? nm noticed on your other post what your doing
I am assuming your like me, and trying to understand what the software is changing on the motor exactly, when you change it, I too have yet to understand fully, I understand the basics, I have...
All changes have been made that you suggested, I will upload tomorrow the 25th
Currently stock 2000 rails and the 29 pound injectors and I have the Open Loop EQ ratio tables set now like you said, I will load tomorrow the 25th, I am looking up the stock IAT timing to put back...
Ok, I scanned it but for some reason it wouldn't save, I have a screenshot of the error I will post or look for on here later, but resetting tps and the iat helped a bunch it now doesn't run you out...
helps a bunch, I see I got a lot to do, the racecarcam tune is the one during the scan. Yes the 29s were in at the time of the scan and are still in currently, I said they are 29's but they are the...
I really appriciate it, I hate it when I think I should do something but I am not certain, I have a wb now with the exhaust hooked up so that should really help, but most of the richness happens at...
Any insight on this, from anyone?
2000 ls1, 92/92 NW/FAST, Ported polished 241 heads , Mahle flat tops with 4cc valve relief, h beams rods, balanced bottom end 242/248 636/636 110lsa cam with .650 lift springs, titanium retainers and...
I now understand I think with the tps reading 2% it is putting my fueling in a different cell, if I am wrong please correct me as I want to know and learn, I work in IT so understanding what all this...
Sorry for this but I have found the tps IAC reset procedure now and believe this could be some of my issue and also found something else I need to log, so hopefully this will help out and looks like...
I just watched the log again sometimes the tps will hit 2%
I may be far off on this but I think that could be a issue
agreed with the above if it done it suddenly and no codes
I have followed the guides for tuning the idle with a large cam, The car already had a sd tune on it, so here is the dilemma, it idles in gear and in P/N (cold or hot) but it idles real rich to the...
I would love to have the beta as well
I am having the same issue only I am running 2.22, scanner saves logs fine but when I read a tune it will not save it, it will say not responding