Search:

Type: Posts; User: EC_Tune

Page 1 of 19 1 2 3 4

Search: Search took 0.02 seconds; generated 37 minute(s) ago.

  1. Replies
    161
    Views
    197,558

    Still available on Amazon.... ...

    Still available on Amazon....

    http://www.amazon.com/NGK-Powerdex-Air-Fuel-Ratio-Monitor/dp/B0018MUNTM
  2. Replies
    19
    Views
    8,351

    I had startup issues on Vette with 2000 CC IDC...

    I had startup issues on Vette with 2000 CC IDC Injectors. Then I remembered the Cranking % table.... Scaled to 20% and Voila! Starts nice every time now...
  3. Replies
    5
    Views
    2,197

    Might need to do a "battery reset". Some...

    Might need to do a "battery reset". Some accessories on the bus don't reset when told to by the MPVI. Your's may be one of them.
  4. You have to fail the MAF to get true SD on most...

    You have to fail the MAF to get true SD on most custom O/S's.
  5. Here's a solution that works. Just get the Speedo...

    Here's a solution that works. Just get the Speedo PPM correct and leave the rest alone. If you don't you're going to fight with the ABS stuff forever. Your shift MPH will be technically "wrong" but...
  6. Replies
    17
    Views
    13,964

    1) Knock gets propagated through the block very...

    1) Knock gets propagated through the block very easily so a single knock sensor will suffice.
    2) Either run without or make an adapter to run the Linear EGR valve. The EGR system on the 0411 is...
  7. The thing I hate about* most* of the "big names"...

    The thing I hate about* most* of the "big names" is all the crapware they force on the machines.
    Especially the pay to play "free" games which generally have some kind of Phone-Home crap too. HP is...
  8. :worship: Love ASUS! :yay: Since they're a...

    :worship: Love ASUS! :yay:

    Since they're a mother board manufacturer (and a very good one too!) I would and have expected the same from their laptop series.

    I got my wife an ASUS a year or...
  9. Replies
    9
    Views
    4,689

    I've seen the base procharger cals.:doh: You're...

    I've seen the base procharger cals.:doh:
    You're better off doing it from scratch....
  10. Thread: Just starting

    by EC_Tune
    Replies
    11
    Views
    6,189

    Glenn, The 07 TBSS uses the E67 ECM so you have...

    Glenn,
    The 07 TBSS uses the E67 ECM so you have to do a write entire every time. I think they are working on a solution for the E67 so you don't have to do a write entire every time. Just wait, they...
  11. Replies
    1
    Views
    1,680

    Send me your stock file & I can convert it for...

    Send me your stock file & I can convert it for you.
  12. Replies
    23
    Views
    17,346

    The Express van uses a 4x crank signal & 1x Cam...

    The Express van uses a 4x crank signal & 1x Cam signal IIRC. So you could get the reluctor & crank sensor from any 5.0 - 5.7 or 7.4Vortec truck engine 96-2000 and use the 2002 Express Van operating...
  13. Replies
    34
    Views
    11,836

    How about turning up the dwell on the coils?...

    How about turning up the dwell on the coils? Stock dwell settings will give those coils 300,000 miles of service. You can run up to 9 msec on them but the longevity goes down quickly above 6 msec. At...
  14. Replies
    6
    Views
    4,612

    Are you going to swap in a 2001+ O/S? hehehe That...

    Are you going to swap in a 2001+ O/S? hehehe That would be the first suggestion <grin>.

    Seats tend to have issues (rocking) as they age on the C5's. Other than that, just a few electrical...
  15. Replies
    9
    Views
    6,827

    BCM would require reprogramming to solve this...

    BCM would require reprogramming to solve this issue. HPT doesn't re-program the BCM though. Tech2 may be your only resource.
  16. Replies
    62
    Views
    44,083

    Files attached for different versions

    Bringing this back from the dead. I made calibrations for the 4 basic versions of a 98 Camaro/Firebird.

    The fuel system segment from a 2002 Express van is installed in each and the fuel level...
  17. Replies
    9
    Views
    6,143

    As a side note: IIRC a Tech2 will write the TCM...

    As a side note:
    IIRC a Tech2 will write the TCM separately from the ECM.

    So, if you have access to a Tech2 you can put the proper cal in the T42 trans controller if you have the right VIN number.
  18. Replies
    5
    Views
    5,077

    Just so others know: You can simply turn off the...

    Just so others know: You can simply turn off the automatic transmission DTC related items for manual operation. Then simply set up the speedo section appropriately.
  19. Replies
    18
    Views
    33,121

    Save your "Stock" file - some good ideas!

    Hi all,

    Here's some good advice from someone who's done it wrong once and lost a stock file. :o

    Right after you read your PCM/ECM/TCM for the first time, save the file as "STOCK.hpt" or...
  20. Replies
    3
    Views
    2,301

    I bet!

    I bet!
  21. Replies
    18
    Views
    28,440

    The spreadsheet will work just fine if you have...

    The spreadsheet will work just fine if you have Greg's DVD and you're not running GM spec'd 58 PSI or 4-Bar (or OEM vacuum referenced on '03 and earlier trucks) fuel pressure. BUT it's ONLY good for...
  22. EVAP plays a big role at/after startup. Log it...

    EVAP plays a big role at/after startup. Log it and see. :D
  23. Replies
    16
    Views
    12,047

    Any reason you can't change the VIN with the "VIN...

    Any reason you can't change the VIN with the "VIN changer" part of HPT? Not sure if you need to read it first though.
  24. Replies
    3
    Views
    2,301

    If you haven't written a file to your PCM then...

    If you haven't written a file to your PCM then the PCM still has the stock file in it. Simply re-read it, save it. Then after saving the stock file, right click "Properties" and make it read only so...
  25. If your inverter output has a common ground to...

    If your inverter output has a common ground to the cig lighter that is the main problem. A simple ohm meter test will tell you right away. Mine is isolated and works all the time every time. No...
Results 1 to 25 of 470
Page 1 of 19 1 2 3 4