Search:

Type: Posts; User: G8Paul

Search: Search took 0.00 seconds.

  1. Replies
    3
    Views
    748

    Makes sense. Thanks guys. My ocd was bugging me...

    Makes sense. Thanks guys. My ocd was bugging me on it, lol.
  2. Replies
    3
    Views
    748

    S/C Bypass Duty Cyle

    Just trying to learn something I haven't been able to figure out. Why would my tuner set the S/C bypass duty cycle min to 0% and max to 200%? I'm assuming to hold the boost obviously, but is that...
  3. Replies
    7
    Views
    1,477

    Your engine torque is exceeding your max engine...

    Your engine torque is exceeding your max engine torque and is closing your throttle. Work the torque tables to get them in line and that should go away.

    Also this situation is one of the most...
  4. Replies
    4
    Views
    1,147

    2016 cts-v 12672585

    2016 cts-v 12672585
  5. Replies
    5
    Views
    1,647

    I could be very wrong here, but from my...

    I could be very wrong here, but from my understanding, changing the throttle area won't do much and the secret sauce is related to the virtual torque table
  6. Replies
    3
    Views
    1,035

    Don't know if this helps or not, but boosted gen...

    Don't know if this helps or not, but boosted gen 5 uses pressure ratio which can be found in math parameters. Not sure if n/a still uses pressure ratio or not.
  7. Replies
    1
    Views
    840

    VVE/SD vs MAF Question

    So if I understand correctly, vve/sd is used(normally under 3000rpm) because of transients and MAP is supposed to react quicker at low rpm. Again this is what I understand. On my logs though, MAF...
  8. Replies
    13
    Views
    17,228

    Happened to me. Went back to normal after about...

    Happened to me. Went back to normal after about an hour.
  9. Replies
    29
    Views
    15,874

    Let me know how it goes. If I'm missing...

    Let me know how it goes. If I'm missing something in the tune, let me know.
  10. Replies
    29
    Views
    15,874

    My torque management is disabled and it chirps...

    My torque management is disabled and it chirps 1-2 every time unless I have been sitting there getting heat soak for a long time. I found that playing with the burst knock retard, delay and atack...
  11. Replies
    21
    Views
    13,161

    Wow nice gains from just raising the rev limiter...

    Wow nice gains from just raising the rev limiter a tad. WHats the safe limit for redline?
  12. Thread: Knock Sensors

    by G8Paul
    Replies
    1
    Views
    1,683

    Knock Sensors

    I am getting some burst knock below 2500 rpm. The knock is magnified when the car switches from 4cyl to 8 cyl. I logged with dod disabled and enabled. I already did the double decay and halve...
  13. Replies
    0
    Views
    1,171

    Couple of Q's please take a look.

    Delete
Results 1 to 13 of 13