Bumping this up. Just fired up my 2015 L83 swap and it takes 5-6 seconds to start. I can log the injector pulse width and there are no pulses until 5-6 seconds then its an instant start when the...
Type: Posts; User: A62WAGON
Bumping this up. Just fired up my 2015 L83 swap and it takes 5-6 seconds to start. I can log the injector pulse width and there are no pulses until 5-6 seconds then its an instant start when the...
I guess it needs to be running. That seems to have done the trick. Will go get into boost and see if it reads correct. Thanks!!!!
I will give it a try.
I was injecting pressure into the intake to bring it to positive pressure to test if it reads above 105 KPA, beats taking it for a drive every time. Shouldn't it read around...
Files attached. Log is with key on, engine off. thanks
Found it. Tried multiple times with removing, repolling, adding it back in. Disconnecting...reconnecting and still no luck.
Well $h1t !!
Still no luck. Connect to vehicle then remove all channels, then add back in the ones I want and it still doesn't work, even just added in the 'MAP-2 Bar' and it still doesn't work. ...
I think I tried that also. Did the 'removal all channels', connected to vehicle then added back in. I don't have an edit and re-poll, so I think I'm doing what you said, once I do this and...
Yeah GM 2 bar map sensor. Car is tuned and it was logging fine with older software, was just looking to fine tune my boost area. Updated to 4.0 and now it won't read past 105.
Map sensor is...
Been searching and trying everything I can with no luck getting it to read over 105 KPA this is a 2002 5.3L with a 2 bar map SD tune. Never had a problem before with old software. Updated to the...
Under FUEL>CUTOFF,DFCO
then tables: DFCO ENTRY SPARK , DFCO ACTIVE SPARK
I zeroed them both. Not sure why that worked, I thought I had it disabled? But now my command was matching log and I felt...
That's odd, I don't show that table.
But its working now. I zeroed out the DFCO table and that took care of it. Don't know why but I'm happy it did.
Thanks for all the help! Really appreciate your...
Attached is a new log of all the timing parameters added that I could find. Am I missing any? Timing still does not match. :banghead: And I don't see anything adding timing
I cant find the...
No i dont have a flex fuel sensor. I'll zero that and log all timing parameters. Hopefully try it tomorrow after work. I'll let you know if that fixes it. Thanks for the help.
Thanks, I will give that a try.
Running about 8 PSI of boost now and when it starts to build boost thats when the timing does not match.
I will try logging all of the timing parameters and...
I need some help please. I've been working on my tune, its a 2 bar SD, plan on running 14 lbs of boost on my 5.3L. The problem I'm having is my timing table is not matching the log and I can't figure...
I need some help please. I've been working on my tune, its a 2 bar SD, plan on running 14 lbs of boost on my 5.3L. The problem I'm having is my timing table is not matching the log and I can't...
I'm having same problem with that and the case relearn
Old computer crashed and now I'm trying to install suite 2.22 on new one and get the .net framework 2.0 error. its already installed along with all the others you listed. What do I need to do. ...