Search:

Type: Posts; User: Bucky

Search: Search took 0.00 seconds; generated 38 minute(s) ago.

  1. Replies
    4
    Views
    2,489

    Not an LQ4, if you are your pushing some air.

    Not an LQ4, if you are your pushing some air.
  2. Replies
    9
    Views
    4,572

    I had a very similar problem, when in D the car...

    I had a very similar problem, when in D the car wanted to stall at idle.

    I ended up changing the TC and Transmission and it fixed it. Not sure what it was but it never threw any codes.
  3. I need to do this also. From what I have read it...

    I need to do this also. From what I have read it you run the signal wire from the o2 to the ground at the PCM for the EGR (double check this). Then run a PID on HPtuners for the EGR to read the o2...
  4. Replies
    13
    Views
    6,121

    You'll have to check the relays and grounds next.

    You'll have to check the relays and grounds next.
  5. Replies
    13
    Views
    6,121

    Fuel Filter??

    Fuel Filter??
  6. Replies
    1
    Views
    1,355

    Its fine dont worry about it. There is no way...

    Its fine dont worry about it. There is no way for it come off.
  7. If you have a standard internal engine, just go...

    If you have a standard internal engine, just go to the junk yard and grab a used one.
    To rebuild yours now means a new crank with bearings and re-size the rods that span, plus bolts and gaskets. ...
  8. Replies
    11
    Views
    5,012

    The knock was still there so I knew something was...

    The knock was still there so I knew something was up and I was running less than standard timing and 94 fuel. At 10deg or KR constantly my pistons would have melted, when I had the engine apart it...
  9. Replies
    11
    Views
    5,012

    Check your knock sensors, I kind of had the same...

    Check your knock sensors, I kind of had the same thing and just recently took the engine out and noticed the rear knock sensor needs replacing, its basically fell apart inside. It was saying I had...
  10. Replies
    18
    Views
    17,192

    I have something that will get the car running,...

    I have something that will get the car running, you just need to change the injector sizing. Its a rough map and still needs tuning though.
  11. Replies
    5
    Views
    3,361

    Done some tuning today and took out a lot of...

    Done some tuning today and took out a lot of spark and added 20% fuel. Safe to drive till my wideband gets delivered. Will keep you posted.
  12. Replies
    5
    Views
    3,361

    Thanks russ, this tune is actually a zzp can tune...

    Thanks russ, this tune is actually a zzp can tune for my mods. Its utter garbage and all over the place. Looks like I am starting again. Its running lean and has loads of kr. Trims are running at...
  13. Replies
    5
    Views
    3,361

    MAF settings were wrong. Tune now is better but...

    MAF settings were wrong. Tune now is better but still need tweaking.
    I have log if people are intrested in looking to help out. No wideband yet, gets delivered in a week.
    I am getting 10deg knock...
  14. Replies
    1
    Views
    2,783

    Changed the gear ratio from 3.29 to 3.69 and done...

    Changed the gear ratio from 3.29 to 3.69 and done the trick.
  15. Replies
    5
    Views
    3,361

    Can someone look at this tune L67

    I have compared this tune I have on PCM with others and the injector scaling seems to be off.
    N* Throttle body
    LQ4 MAF
    42.5lb Injectors Bosch Greens
    XP Hot Cam

    I am hitting 180kpa but my...
  16. Replies
    1
    Views
    2,783

    4T65E Gear ratio question

    OK I have a quick and simple question.

    My tune has stock 2.93 for a GTP and I have now changed the tranny from a GT and now has 3.29 for the gear ratios. I changed over the diff to the HD one.
    ...
Results 1 to 16 of 16