Search:

Which of the 4 oxygen sensor wires is the signal wire i need to hook the analog 5v from the wideband to?

I am replacing the right front sensor, my wires are Pink, Black, Purple, Tan

I am...

so should i try to install this in the X Pipe portion, or is it ok to just install the wb on one bank after the collector? i guess i am gonna keep the stock nb sensors in...1) for a sanity check,...

Can I just turn off the DTC code for the passenger side O2 sensor heater (since that is the one i am replacing with WB), instead of using a resistor??? or will that through the pcm into a different...

I just got an email from plx and in it they said "install 2 10ohm 20W resistor in between heater + and - to fool ECU, or OBDII cars 1k ohm 10W"

in this post it said to use 20 ohm not 1k ohm??????

yes but which O2 signal wire... the narrow or wide band?

Here is what I plan to do....need some help
I will be replacing the stock NB sensor with the WB on a 2002 Camaro Z28.

I plan on disabling the SES light for the stock heater and capping those...

I have no cats, the x pipe near the tail shaft of the tranny, is that too far back??

well i ordered the plx setup with the D5 gauge.

i know there is a harness to hook the WB up to the sensor box, but is there a wire harness to hook up the analog feature to the stock narrowband o2...

Let me get this straight, I can just swap a stock narrowband for the wideband and the car will still operate normally as if it was still the stock narrowband sensor. how do you hook it up to your...

I am wanting to get a Wideband, I did some searches and still have no idea on what to get.

What I want is to be able to have an actual digital gage on my pillar plus be able to hook it up to...