Drove the car this weekend on a road trip with a few friends. Let one of them drive some too. So far the issue hasn't come back after my latest cal change. Hopefully that was the issue. Once I...
Type: Posts; User: LS3RX7
Drove the car this weekend on a road trip with a few friends. Let one of them drive some too. So far the issue hasn't come back after my latest cal change. Hopefully that was the issue. Once I...
I have changed the coolant thresholds for the P101, 106, 121 to now run unless less than -40C. I will have to see how it works for my issue and if it fixes it. Hopefully that does it.
Hello all,
I have an engine (6L, LS3 heads/intake manifold, aftermarket pistons/cam/rods, bored .030 over) being controlled by an E40 2006 GTO controller/cal/pedal/throttle. Currently I have it...
So I have my project car running as an '06 GTO LS2 E40 ECM. Over the weekend it seems DFCO stopped working for some reason. When I do a tipout, i am close to the airflow requirement, but another...
I would pin out the harness and ECU and see if it is right for the TPS connection....
When I log in to download this, I see that 2.24 is the latest suite to download. How do I go about downloading this Beta version to check it out?
It sucks, but Gen 4 isn't supported with RTT and it sounds like they aren't even working on it......
You sure it is running on your high octane map and not the low? Is the timing lining up with your low octane map?
P.S. - I didn't download your tune at all to check
How do I convince you guys to please work on it for Gen 4 E40 ECM's? ha.
Is RTT for Gen 4 ECM's being worked on, or it isn't a possibility? I bought HP Tuners because of RTT not realizing it was only Gen 3 ECM's, ha. Still a good product, but wish I had known ahead of...
It might have done it before but the new cam makes the motor more sensitive to the EQR change....
I tried to setup a histogram to be MAF (Hz) as the axis, and then populate fuel trim in the cells so that I can tune the MAF. I cannot get the histogram to work though. I added MAF (Hz) to the...
So attached is the cal, some log files, and my config file....
I thought that could be an issue, but it seems weird to me that when the IAC closes, the idle jumps up. You would think when the IAC closes, the idle would drop, no?
It seems the rpm jumps when...
So I am helping a co-worker that has the following setp:
2001 5.3L with cable throttle
P59 from 2003 with the blue and green connectors
Running a XR269HR Comp Cams 269/273 .525/.532 114LSA
243...
So in the system tab, I can just setup the platform as one that does not use DBW and it should be just fine then?? That way I could tune with the stock 5.3L truck engine and run it as DBC while only...
I will also being doing something similar, and would rather not use double credits. I think though, if you linked to the ECU, that would be 1 set of credits, then to load in a different cal than...