I have an isuzu box truck 6.0l with custom OS and was unable to tune,swaped with 06 truck pcm and all is well except a/c.Box truck has a pressure sensor not switch,is there any"fix"for this...
Type: Posts; User: Filapoosis
I have an isuzu box truck 6.0l with custom OS and was unable to tune,swaped with 06 truck pcm and all is well except a/c.Box truck has a pressure sensor not switch,is there any"fix"for this...
It has been a week and a half now, and I still have no response from tech. Can I get an idea of when this is going to be rectified?
I am having the normal issue with a 1997 Corvette PCM. I realize that the file needs to be sent to support, and I have already done this. Hoping that potentially someone can get the updated file to...
Just resent it, thanks for the help.
Sent an email to support earlier today. Not trying to be worrisome but am in need of the new Beta for some 2010 Camaro tuning. Thanks in advance for any help.
That's exactly what I needed!
That works fine on the 4L60s, not working for me with the 6L80.
What's the "trick" for keeping the A6 in gear on the dyno. Even using the paddle shifts won't leave the car in gear.
Thanks in advance for any advice.
What's the "trick" for keeping the A6 in gear on the dyno. Even using the paddle shifts won't leave the car in gear.
Thanks in advance for any advice.
This is the second time this has occured with an '06-'07 C6. Upon writing the PCM the car will not start and will not recognize the fobs, but I can still read/write the PCM. Has anyone else...
We're out of Raleigh and would be happy to help. Mayhem Motorsports (919) 852-3766.
I recently installed a new from GM (unported) throttle body on my 2006 Corvette. I now have the P2127 code that will not reset. I have searched the forums and can not find any information relevant...
I put an aftermarket tank and the sender reads from 0-90 ohms. How do I adjust this in my file. Also how is the scale figured out on the sender charts.
I attached my file.
thanks
thanks it worked
You have a PM on the way, Keith.
yes I am running a 3bar map sensor. When I pull the file out of my computer it pulls out the same file as above.
here is my config file with the changes on the max MAP value.
well I did the write entire and still dont have that option. Anything else you can think of? Or can I send you my config and you take a look at it?
I went into the chart configuration and went to chart 2 and changed the max KPA from 105 to 315. Will this work or will it still read incorrect?
yea I did.
yes
I did exactly what you posted. I connected to the car. Went to display -> table. Then right clicked on the Manifold Air Pressure and deleted it. Then right clicked on that block hit insert. Went to...
when I right click and go to insert. It only shows Manifold Air Pressure. It does not show the 2 or 3bar options.
here is my scan file.
I have a 3bar tune in my car and when we scan it the scanner only goes up to 1bar. I attached my file below.
Thanks for the help Keith. Now I have another question...I wanted to register all Gen III GM cars (30 credits), and it is only giving me the options for all LS1 cars (70 credits), single vehicle, or...
PM sent