I need 2 bar MAP, but none of the enhancements are available!
I have 8 credits, for module 2009
How to available?
Type: Posts; User: yousuf
I need 2 bar MAP, but none of the enhancements are available!
I have 8 credits, for module 2009
How to available?
Same problem ... Noting happen when paste :(
I try click copy with labels and go into my tune file and click paste special, nothing change!
How to solve that ?
Before u used to do it and it work.
Does they connect to hp tuner interface?
If I want to connect wide band O2 sensor to hp MPVI pro interface for tuning VE long/ short trem on the road, which brand is best to use (wide band O2 sensor brand)?
If RPM does not start, what the problem could be?
Yes it is
i switched from a 24x to 58x tooth crankshaft mounted reluctor ring, but the car did not start.
I had a car with crankshaft reluctor ring "24" , I bought now "58" , also crankshaft position sensors "58", I need to know where can I change at the program from 24 to 58 , so I can start the car.
Can you explain for me more, please.
Hi
How can I tune LS1 without MAF,IAT and O2 sensor?
Thanks i will do it
I changed throttle to manual,
Do I have to change the VCM or make some sensors off?
Yes
i got this message when i try to write file to VCM:
"The interface was found but no vehicle power was detected.
Verify cable is connected and key is in the RUN position,
Also make sure the...
Hi
I have a used VCM, and i want to install on V8
how can i input the information from the old VCM to that one direct not manual?
MAF is off
Fuel 95
Boch regulator
I tuned a car,
i changed all value in power enrichment table to 1.225, enrichment rate 2.0, delay RPM 0, and fuel regulator 58 psi.*
When I test the car with full throttle, EFR became 10.3, and INJ...
I tuned a car,
i changed all value in power enrichment table to 1.225, enrichment rate 2.0, delay RPM 0, and fuel regulator 58 psi.
When I test the car with full throttle, EFR became 10.3, and...
I want to tune MAf & VE.
I enabled STFT Openloop, closed loop enabled: 130, LTFT enabled, Min ECT 113, Max ECT 284, CAT Over Temp Protection disabled. But in scan the LTFT B1/B2 and STST B1/B2 is...
Ok , thank u
Hi shrek
Thank you for replay
How to disable VATS?
I bought a used vcm for chevrolet corvette 5.7 engine.
Now the car does not start over more than 2 sec !!
Does it have to do with security? or something else?