Search:

Ed, The weather turned to crap today. I was looking forward to going to the track this weekend, but that will have to wait. After the weather clears up ill try setting the burst knock back to stock...

Thank you guys for the help! I was going to change the tune in two steps, but I went ahead and zeroed out the burst knock and I also changed more of the torque management settings. I'm not sure...

Thanks Ed! I'll give that a try too. Hopefully after I get out of work tonight I can go log another run or two.

John

What should I change in torque management? I don't know much about that area in hptuners. Thank you!

I'm not sure what info you need for the car, if you need other info let me know:
Car: 1997 Camaro
2001 LM7 with 223/223 114+5 cam
4l80E with 3200 rpm billet single disk circle D converter
2 bar...

I found the problem after reading this thread(post #2):

http://www.hptuners.com/forum/showthread.php?37604-Converting-MAP-kPa-to-boost-in-PSI

I had attempted to put a user defined pid to log...

I just tried the scanner again with the maf deleted from the charts and it didn't make a difference. Here is the scanner i'm using.

I was just reviewing my scanner and in the charts display it was still showing the MAF. I deleted it from the chart display. Could this be affecting my Map reading in the histogram and chart? It's...

Do I need to add anything else or does what i'm asking make sense?

I tried key on with the linear at 200 and offset at 10.33 and I was at 83 kpa or so. I switched it back to an offset of 8 and...

I followed this for the scanner:

https://www.hptuners.com/help/vcm_editor_parameters_gm_os.htm

I set up to start tuning for the VE table using the 2 bar OS using this:
...

What i'm saying is my entire exhaust is currently only 18" long. The wideband is about 8" from the turbo and it has about 10" of exhaust after the wideband.

45T-XR i'm going to pull the plugs...

It smells rich but it could be just the fumes from having only an 18" exhaust. I was planning to take it to the exhaust shop this week or next. I have a 5.3 lm7 with a 223/223 at 114+5 cam, so I...

I've just got my car started after my turbo install and i'm trying to tune it using the wideband. I switched to a 2bar speed density tune. So far its only idling on jack stands. I haven't drove it...