Search:

Type: Posts; User: z28rob18

Search: Search took 0.00 seconds.

  1. Replies
    3
    Views
    1,957

    Any help?

    Any help?
  2. Replies
    3
    Views
    1,957

    I fixed the throttle hang since this log. I also...

    I fixed the throttle hang since this log. I also made a fuel adjustment in the upper RPM where it went unsafe lean.

    6036060361
  3. Replies
    3
    Views
    1,957

    Lean when revving/burnout

    Took the car to the track the other day to take a look at the tune and It was showing it was WAY lean during the burnout and when revving up at the line. The AFR is pretty steady around 11.8 during...
  4. Replies
    3
    Views
    1,605

    here's another short log I did after using the...

    here's another short log I did after using the AFR error to adjust the VE table I think I have it going in the right direction. This is with long term fuel trims disabled maf disabled and PE disabled.
  5. Replies
    3
    Views
    1,605

    I bought the pcm with a mail tune on it for the...

    I bought the pcm with a mail tune on it for the car. The injectors are set from what I can tell. They're 42# injectors. The flow rate VS. KPA shows 44. I've notice stoich at 14.84 and didn't know if...
  6. Replies
    3
    Views
    1,605

    Please help review my tune

    I have a 95 Camaro it is a 385 lt1 with the 24x conversion so it runs on an 02 pcm. the car runs and drives, but since getting my wideband working it seems its on the lean side and it worries me to...
  7. Replies
    10
    Views
    5,189

    your walk through helped the afr error reads when...

    your walk through helped the afr error reads when tuning with the wideband/AFR error do I leave PE mode enabled? I did a real short log with the car up to temp and its lean for the most part I'll...
  8. Replies
    10
    Views
    5,189

    For VE but I think your fuel trim how to should...

    For VE but I think your fuel trim how to should give me some guidance
  9. Replies
    10
    Views
    5,189

    That got it reading. Can you help me set up a...

    That got it reading. Can you help me set up a graph/histogram for it
  10. Replies
    10
    Views
    5,189

    Trying to plug into the interface with the green...

    Trying to plug into the interface with the green strip
  11. Replies
    10
    Views
    5,189

    How to set up LC2 on 3.0

    I need some help setting up my innovate motorsports lc2 in the scanner I found how to do it in the 2.24 and when I started using 2.25 and now 3.0 I can't figure it out. I've added the channel under...
  12. Replies
    0
    Views
    1,358

    New to this 95 lt1 24x help

    I finally got HPtuners working had some issues but I scanned the car tonight and I have a bunch of codes that read MIL on second error. Codes from the TPS MAF coils injectors coolant sensors (which...
Results 1 to 12 of 12