Search:

Type: Posts; User: waynehartwig

Page 1 of 20 1 2 3 4

Search: Search took 0.00 seconds.

  1. Replies
    25
    Views
    18,231

    If you have "a proven custom tune that does away...

    If you have "a proven custom tune that does away for the input speed sensor" then what do you need help with?
  2. Sticky: Correct. They're about $50 around here. Dealer...

    Correct. They're about $50 around here. Dealer can flash the correct VIN in it for about $150. I can do it for $50 and shipping.

    In your email, you asked to do the 60 to 80 swap, that's $150 and...
  3. Sticky: The best thing you can do if it fails is NOT to...

    The best thing you can do if it fails is NOT to turn the key off and just try writing again. It sounds like you're beyond that, though. Now the only thing you can try is to remove the battery cable...
  4. ETC Corrections Help Needed w/KB Mammoth

    So I have a 2014 Shelby in the shop where I just put a Kenne Bell Mammoth supercharger on it. Of course, as you would expect, it needs some tuning to compensate for the bigger throttle body - and...
  5. Replies
    0
    Views
    985

    Too fat at idle? Injector timing?

    Put a new cam in an LS2 (LS3 heads, intake, TB. LS9 injectors). Long tube headers with wideband in the collector. Cam is TSP stage 4, F35 I think they call it - 235/248 .649/.615 on a 111 lsa. Idle...
  6. Replies
    2
    Views
    1,028

    Awesome! Thanks!!

    Awesome! Thanks!!
  7. Replies
    2
    Views
    1,028

    Looking for stock 2012 Raptor file 6.2

    Customer brought in his truck that was tuned by someone else with issues. I can't save/view the curent file, as it says there is a mismatch. I don't do much Ford, so I don't have a stock file to...
  8. Replies
    43
    Views
    27,965

    I'm not a big Dodge guy but it seems like if you...

    I'm not a big Dodge guy but it seems like if you disable it, do the SD tuning, and then re-enable it, things work good. Like I say, maybe I haven't done any heavy mods where this might be an issue...
  9. Replies
    288
    Views
    311,049

    Lots going on. Try the stock tune.

    Lots going on. Try the stock tune.
  10. Replies
    119
    Views
    112,902

    Simply replace D4 with D6 then

    Simply replace D4 with D6 then
  11. E38 can read both, 24x or 58x

    E38 can read both, 24x or 58x
  12. Replies
    12
    Views
    4,205

    I don't see where to do that with HP. I've tried...

    I don't see where to do that with HP. I've tried looking. Any ideas where it might be and i'll look closer? Only thing I see under 'torque management' is calculated load. I know fuel rail pressure...
  13. Replies
    12
    Views
    4,205

    Would the injector flow rates have anything to do...

    Would the injector flow rates have anything to do with it? The customer doesn't have flow info (he thinks they are 30%?), or I would have already plugged that long number in with a Tech2.
  14. Replies
    12
    Views
    4,205

    Any more ideas? Put a new MAF in it today and...

    Any more ideas? Put a new MAF in it today and while it seemed to make it run better, it didn't resolve the issue. MAF wasn't reading before, but now it is.
  15. Replies
    12
    Views
    4,205

    Sorry for the delay, but I finally got the truck...

    Sorry for the delay, but I finally got the truck back in today. Popped it in, and still does it. Any other ideas? I reset the codes in the scanner and it will rev for a few seconds then fall back...
  16. Replies
    12
    Views
    4,205

    85122 i think i did it right?

    85122
    i think i did it right?
  17. Replies
    12
    Views
    4,205

    Obviously the engine is far from stock so i've...

    Obviously the engine is far from stock so i've deleted things like EGR and etc and no codes show up. I go through and enable every code and other than the EGR codes, there is only one code that...
  18. Replies
    12
    Views
    4,205

    limp mode with aftermarket turbo

    I have a swapped Duramax with a limp mode issue. Aftermarket turbo. Tried deleting all of the vane codes and still no luck. If I hold my foot to the floor and delete codes at the same time, it will...
  19. Replies
    0
    Views
    981

    park neutral rev limit on 06 lbz?

    Not the issue but I can't figure out how to delete the thread
  20. Replies
    150
    Views
    438,507

    Upload your tune if you want help. Use the...

    Upload your tune if you want help. Use the attachment feature
  21. Replies
    107
    Views
    237,248

    Has this not been upgraded in a few months? I...

    Has this not been upgraded in a few months? I keep only downloading 3.6.26. Tried the link in this thread and on my home page, same thing.
  22. ...unless you convert to a 2bar or etc custom os

    ...unless you convert to a 2bar or etc custom os
  23. 6lxx is PRNDM maybe PRNDM21 in some rigs. Could...

    6lxx is PRNDM maybe PRNDM21 in some rigs. Could even be PRND M/S, if it has sport mode. But definitely not PRND654321 or whatever.
  24. The black box on the side of the trans is a park...

    The black box on the side of the trans is a park neutral position switch. It's entire job is to tell the PRNDL on the dash what to do, back up lights and tell the computer when it's ok to run the...
  25. Replies
    82
    Views
    46,803

    I do it all the time and have never had an issue....

    I do it all the time and have never had an issue. Tuned 5 today, granted they were all gen3's, but I've done other years with no issue. Did a 08 Yukon 6.2 on the dyno Saturday, where I flashed it...
Results 1 to 25 of 486
Page 1 of 20 1 2 3 4