thanks for the information
Type: Posts; User: Undre75
thanks for the information
145296
145297
Ok, I didn't know, thanks
I got a 1979 cutlass ls swap 5.3, I have a th350 trans with the Dakota digital sending until electrical speedometer and I've researched the hp tuner site and YouTube on how to calibrate my speedo. I...
thank you
Is there a target numbers for the VE table? As far as the over/underspeed spark being as such, I have no clue. I had a tune done and I guess that's the results of trusting the tuner would be legit.
I'm having a few issues with my build. first issue is the knock retard hits around 4,000 - 4,400 rpms. second issue I'm having hunting idle when I start slowing down coming to a complete stop. I have...
thanks a lot, after I address the knock sensor issue are you open to doing a nice tune for me via email
I did a scan and the code is 0x10: P0332 - Knock Sensor 2 Circuit Low (Bank 2) (Pending, Current)
I'm so frustrated with it because I'm far from a tuner. What would it cost to have it tuned via mail to correct my issues
wow can I get a start point!
ok and I'll let you know. I appreciate your time and input
no, I haven't
My project 1979 Cutlass, LS swapped 5.3 (LM7) with Texas Speed cam stage 2 w/ LS6 valve springs. How can I go about addressing knock retard. I'm having knock in 4,000 - 4,400 rpm range. I have files...
my harness is from geartronics
111511
here's my tune file
I've changed the thing 3 times, I went to summit and got a new map sensor and the rubber tip was gray but the others were red or orange and all three have different part numbers
111510
Hey 5FDP, i changed my O2's and those are good. Now I'm getting readings from them both. Now my other issues is my MAP reading 104pka. When key is off MAP reading 12kpa but with key on it...
111508
Hey 5FDP, i changed my O2's and those are good. Now I'm getting readings from them both. Now my other issues is my MAP reading 104pka. When key is off MAP reading 12kpa but with key on it...
my O2 sensor are the wrong ones. I was told to get the 99 firebird upstream O2's, which have a shorter element at the center of the O2's. which I need the ones with the long element at the center. I...
[QUOTE=5FDP;654931]Double check that the scanner is reading it correctly. Try removing the MAP sensor channel in the scanner, then connect to the vehicle with the scanner, click vehicle at the top...
still the same
ok thank you and I'll keep you posted.
thanks you going to do that now
I know what it is for. I want to know what's some solutions if any