What am I missing? Trying to send tune to OZ but my interface says not supported on RTD flasher when I click to read vehicle.?
Type: Posts; User: midevil1
What am I missing? Trying to send tune to OZ but my interface says not supported on RTD flasher when I click to read vehicle.?
I am looking for 50hp max. I would like to tune it for E85...
Has anyone tuned one yet? Power gains? What stock parts are holding it back?
Did you add a flex fuel sensor into fuel system? Your car is not equipped from factory for E85.
thanks, i will.
PM sent
thanks,
Need real world results if you have any... who has the strongest tune for a N/A E70 setup? I say E70 because that is as high as I have seen with my Pro Flex setup. Looking to make 520plus whp with...
CC is NOW WORKING! Used it several times yesterday. Haven't had CC for 2 years! You the man PSM 6.4...
Revised tune
Still no CC. Only code that comes back is P0488.
I will try it this weekend. I have to change alot of fueling and timing in that tune for this new turbo..
P179A and P0488 still comeback. Forscan, HP and Edge CTS3 all catch them..
Here is current tune. I just installed bigger billet BB turbo so truck might get sent to toy duty and I will buy a Dually for towing..
Jaegerwrenching and another user sent me a disabled tune of mine. They did the above with HP tuners and still no CC.
The 2 codes I have narrowed it down to are P0179A and P2263. VGT actuator and Turbo performance codes.
I am not a member on those forums. I have searched them and found where they say its in the tune. Possibly a DTC. I am an open door when it comes to sharing tuning. Closed doors is what I see trying...
My truck doesn't require a "RECAL" of the brake switch. If they did I wouldn't own it..
Not familiar with Antibounce term.? Another name for it?
No recal needed. If you read my post, I have tested all the way to the ECM pin out for both cruise circuits.
P0179A and P0488 are the only codes I have.. they are disabled but still show as MIL-off. Anybody know what else you can do besides disable the codes?
here you go. i think my problem is a DTC that is not showing up in the scanner or my engine diagnostic tool.
Please Elaborate...
I have replaced all of the parts involved with the cruise control. From steering wheel to master cylinder. Everything is working on that end. Power and signal to ecm when set..
I would greatly appreciate it, buddy. I get no codes for VGT with it enabled or disabled..
I have tried enabled and disabled. Trying it enabled with zero'd out parameters this weekend. Kem Performance supposedly figured this out but he hasn't been in business since 2019.