Guess this thread is dead
Type: Posts; User: TXZ0603
Guess this thread is dead
just downloaded this. using with hptuners. I added the car information in however when I try to load the car i get this error:
See the end of this message for details on invoking
just-in-time...
Any support for the 00 V10? I really do not want to buy another tuning suite
Picking up an 06 2500 Cummins. Can I tune with this software or do I need to go buy something that will?
Ha! Hadnt noticed that. It was a long drive and I really didnt even think about it. My last DJ was 784 at 16 psi on meth with smaller turbos.
Yes I added my weight. I figured the SAE would...
Ill give that a try
Thanks. It was taken with 2.23
Mods in sig
100 deg here in houston
ok I isolated just the one run in the csv file. This looks alot better
http://i12.photobucket.com/albums/a243/Slvr04/1086hp.jpg
yea that was 2 pulls. Is that what made it slew all over the place or just what gave the high number?
Fun software. I just gave it a try on mine, heres what i came up with
No meth, low timing, 18# boost
http://i12.photobucket.com/albums/a243/Slvr04/Untitled.jpg
This should be a sticky
Have you installed a 2 bar map? If so are you SURE its a 2bar map?
Here is mine on a 3bar os. Not sure why yours reads in Kpa.
http://a3.sphotos.ak.fbcdn.net/hphotos-ak-snc6/251215_2036536963525_1547254753_32109437_4624358_n.jpg
Wish you were closer to Texas.
vacuum leak?
Swap the outside 2 pins.
Brett, what was the outcome? Did any previous credits apply to the unlimited license?
Im sure I overlooked this, but how many credits are needed for unlimited GEN 3? Also do any of my used gen3 credits apply towards this?
Thanks
Sorry to hear bro. I know the pain of it though. My 7K forged boosted motor is puffing some oil. Although for mine, all the compression is good and only 10-15% leak down on 2 cylinders. This damn...
If your IAT is reading 284 cold, you have a wiring issue, not tune
if you are concerned if an injector is stuck, transfer them bank to bank and see if it happens on bank2. Dont see the tune or your cfg file
Fixed it. Unchecked the 102 and 103 ses enable codes. Also set the MAF fail to 12.5Hz. Worked like a charm. Thanks Russ
Thanks Russ. It looks odd cause I am spraying a MESS load of meth on the top end
Pulled the codes on both the DIC and through my HPTuners. The only codes showing are the p0102 and p0103. My car is in SD so they should be there. I have them set to 2-no mil light. Been like this...
are you resetting trims each time? Wideband? Using afr error? post tune, log, and cfg along with mod list. No one can help you without that.